Abstract:Determination of heat transfer coefficients for flowing packed particle beds is essential to the design of particle heat exchangers, and other thermal processes. While such dense granular flows fall into the well-known plug-flow regime, the discrete nature of granular materials alters the thermal transport processes in both the near-wall and bulk regions of flowing particle beds from their stationary counterparts. As a result, heat transfer correlations based on the stationary particle bed thermal conductivity could be inadequate for flowing particles in a heat exchanger. Earlier works have achieved reasonable agreement with experiments by treating granular media as a plug-flow continuum with a near-wall thermal resistance in series. However, the properties of the continuum were often obtained from measurements on stationary beds owing to the difficulty of flowing bed measurements. In this work, it was found that the properties of a stationary bed are highly sensitive to the method of particle packing and there is a decrease in the particle bed thermal conductivity and increase in the near-wall thermal resistance, measured as an effective air gap thickness, on the onset of particle flow. These variations in the thermophysical properties of stationary and flowing particle beds can lead to errors in heat transfer coefficient calculations. Therefore, the heat transfer coefficients for granular flows were calculated using experimentally determined flowing particle bed thermal conductivity and near-wall air gap for ceramic particles -CARBOCP40/100(275 um), HSP40/70(404um) and HSP16/30(956um); at velocities of 5-15mms-1; and temperatures of 300-650C. The thermal conductivity and air gap values for CP40/100 and HSP40/70 were further used to calculate heat transfer coefficients across different particle bed temperatures and velocities for different parallel-plate heat exchanger dimensions.

Heat Transfer in a Fixed Bed of Cobalt-based Catalyst with Flowing Gas

Effective Thermal Conductivity of Fixed Packing Bed of Cobalt-based Catalyst

Heat Transfer Characteristics Analysis and Optimization of the Micro Packed Bed Bionic Reactor

Thermal Distribution in Axial-Flow Fixed Bed with Flowing Gas

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Experimental and simulation study of the temperature distribution in a bench‐scale fixed bed Fischer–Tropsch reactor

A Study of the Heat Transfer Characteristics of Novel Ni‐foam Structured Catalysts

Study on Cross-flow Heat Transfer in Fixed Bed

STUDY ON ENGINEERING PARAMETERS OF A301 AMMONIA SYNTHESIS CATALYST Ⅱ EXPERIMENTAL MEASUREMENT OF FIXED-BED HEAT TRANSFER PARAMETERS

Cross-flow Heat Transfer in Fixed Bed

Thermal Conductivity of Cobalt-Based Catalyst for Fischer–Tropsch Synthesis

Numerical Determination of Fluid‐to‐particle Mass and Heat Transfer Coefficients in Packed Bed Reactors

Thermal Maps of Gases in Heterogeneous Reactions

Heat transfer in circulating fluidized bed and its modeling

A unified approach to the convective heat transfer in packed beds

Heat Transfer Coefficients of Moving Particle Beds from Flow-Dependent Particle Bed Thermal Conductivity and Near-Wall Resistance

Bed-to-surface heat transfer in a BFB oxy-fuel combustor

Study on Effective Radial Thermal Conductivity of Gas Flow Through A Methanol Reactor

Fluid Flow and Heat Transfer in the Shell Side of a Cross-flow Fixed-bed Reactor for Propylene Oxidation

CFD Study on Thermal Transport in Open-Cell Metal Foams with and Without a Washcoat: Effective Thermal Conductivity and Gas-Solid Interfacial Heat Transfer