Abstract:Abstract The heat conduction performance of the methanol synthesis reactor is significant for the development of large-scale methanol production. The present work has measured the temperature distribution in the fixed bed at air volumetric flow rate 2.4–7 m3 · h−1, inlet air temperature 160–200°C and heating tube temperature 210–270°C. The effective radial thermal conductivity and effective wall heat transfer coefficient were derived based on the steady-state measurements and the two-dimensional heat transfer model. A correlation was proposed based on the experimental data, which related well the Nusselt number and the effective radial thermal conductivity to the particle Reynolds number ranging from 59.2 to 175.8. The heat transfer model combined with the correlation was used to calculate the temperature profiles. A comparison with the predicated temperature and the measurements was illustrated and the results showed that the predication agreed very well with the experimental results. All the absolute values of the relative errors were less than 10%, and the model was veriﬁed by experiments. Comparing the correlations of both this work with previously published showed that there are considerable discrepancies among them due to different experimental conditions. The influence of the particle Reynolds number on the temperature distribution inside the bed was also discussed and it was shown that improving particle Reynolds number contributed to enhance heat transfer in the fixed bed.

STUDY ON ENGINEERING PARAMETERS OF A301 AMMONIA SYNTHESIS CATALYST Ⅱ EXPERIMENTAL MEASUREMENT OF FIXED-BED HEAT TRANSFER PARAMETERS

Heat Transfer Characteristics Analysis and Optimization of the Micro Packed Bed Bionic Reactor

STUDY ON ENGINEERING PARAMETERS OF A301 AMMONIA SYNTHESIS CATALYST ⅠDETERMINATION OF SHAPE FACTOR

Heat Transfer in a Fixed Bed of Cobalt-based Catalyst with Flowing Gas

Intrinsic Kinetics of A301 Ammonia Synthesis Catalyst

Study on Cross-flow Heat Transfer in Fixed Bed

Cross-flow Heat Transfer in Fixed Bed

Experimental and simulation study of the temperature distribution in a bench‐scale fixed bed Fischer–Tropsch reactor

Thermal Distribution in Axial-Flow Fixed Bed with Flowing Gas

Three-dimensional Numerical Study on Finned Reactor Configurations for Ammonia Thermochemical Sorption Energy Storage

Experimental and Numerical Investigation of Enhancement of Heat and Mass Transfer in Adsorbent Beds

A New Modeling Method to Evaluate Effective Forced-Convective Heat Transfer Rate of Pipe Flow with Endothermic Chemical Reactions

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

Study on Effective Radial Thermal Conductivity of Gas Flow Through A Methanol Reactor

INTRAPARTICLE DIFFUSION EFFICIENCY FACTOR OF IRREGULAR A301 AMMONIA SYNTHESIS CATALYST

Experimental Study of Heat and Mass Transfer for Ammonia-Water Falling Film Absorption on Novel S-shaped Capillary Tubes Bundle

Analytical and Experiment Study on the Chemical Reaction Kinetics of Composite Adsorbent-Ammonia Working Pair

A Study of the Heat Transfer Characteristics of Novel Ni‐foam Structured Catalysts

Cold Model Experiment and Simulation of Autothermal Reforming Reactor

Experimental Investigation of Heat Transfer Characteristics of Propane Condensation in Helical Baffle Shell-tube Heat Exchanger

Identifying Heat and Mass Transfer Characteristics of Metal Hydride Reactor During Adsorption: Improved Formulation about Parameter Analysis