Abstract:On the basis of previous experimental studies of two-phase flow condensation heat transfer for R134a inside the horizontal micro-fin tubes, a theoretically analysis of heat transfer characteristic combining both heat transfer mechanism and flow mechanism is discussed by the experimental data of heat transfer coefficient and pressure drop, to further clarify the influence of experimental condition and tube structure on heat transfer characteristics under the special working condition. Two performance factors, enhancement factor (EF) and penalty factor (PF), are introduced to quantitatively compare the effect of micro-fin on the heat transfer coefficient and the pressure drop between enhance tube and smooth tube. Meanwhile, the comprehensive factor, CHF, is applied to evaluate the comprehensive performance of heat transfer tube. It was found that enhancement factor (EF) and penalty factor (PF) both increase with increasing mass flux and fin helical angle, and decreasing saturation temperature, the comprehensive factor, CHF, is always greater than one and increases with increasing fin helical angle and mass flux, and decreasing saturation temperature. Moreover, based on the comparative analysis findings that some existing correlations of heat transfer characteristics underestimate most of the experimental data, and the experimental variable has great influences on the correlation prediction accuracy, such as mass flux, which is proportionate to the prediction deviation of correlation. Therefore, a new correlation was developed through analyzing quantitatively influencing mechanism of the experimental variable on the heat transfer characteristics, in a way that a two-phase frictional multiplier is defined firstly from the experimental data and then the forced convection heat transfer mechanism is redefined based on the comprehensive effect of various experimental variables. By the experimental data verification, the new correlation shows good prediction effect with the mean deviation of less than 5%.

Experimental and Numerical Investigation of Enhancement of Heat and Mass Transfer in Adsorbent Beds

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Numerical simulation on heat transfer performance in fin-plate adsorption bed

Mathematical Model and Numerical Solution of the Heat Transfer Process in the Solid Adsorption System

Effect of fines addition on heat transfer performance in gas-solid fluidized bed: An integrated experimental, simulation, and theoretical study

Performance Study of Heat and Mass Transfer in an Adsorption Process by Numerical Simulation

Study of adsorption performance of vertical radial flow dual-bed adsorber used in air sparation unit

Fabrication and Thermal Conductivity Improvement of Novel Composite Adsorbents Adding with Nanoparticles

Numerical investigation and response surface optimization of a sorption heat storage systems performance using Y-shaped fins

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Effect of Operating Parameters on Gas‐Solid Hydrodynamics and Heat Transfer in a Spouted Bed

Numerical Simulation of Low Calorific Gas Combustion and Heat Transfer in Porous Media

Experimental and Numerical Investigation into the Heat- and Mass-Transfer Processes of n -Butane Adsorption on Activated Carbon

Experimental study on gas–liquid interfacial area and mass transfer coefficient in three-phase circulating fluidized beds

Numerical investigation of transient gas–solid heat transfer in a packed bed: Impact of intra-particle thermal diffusion

The heat and mass transfer performance of facile synthesized silica gel/carbon-fiber based consolidated composite adsorbents developed by freeze-drying method

Heat transfer in circulating fluidized bed and its modeling

Dynamics of Heat and Mass Transfer during the Injection of Dispersed Adsorbent into Steam-Gas Flow

Numerical simulation of gas–solid heat transfer characteristics of porous structure composed of high-temperature particles in moving bed

Numerical Modelling of Flow and Coupled Mass and Heat Transfer in an Adsorption Process

Investigation of Gas-Solid Flow Dynamics and Heat Transfer in Fluidized Beds by Using DEM-LES Coupling Approach