Abstract:The blast pressure acting on the borehole wall is the basis of the dynamic analysis of rock blasting. The history of blast-induced borehole wall pressure (BWP) is difficult to measure owing to the complex interaction between the blasting load and the borehole wall, and the limitations of the general test system. In this work, the complete history of BWP under air-deck charge was measured for the first time, and the stress-response process was analyzed. PVDF (polyvinylidene fluoride) gages and a charge mode for the test circuit were employed. To improve the testing accuracy, the matching relationships among the parallel capacitor, the equivalent capacitance of PVDF gages, and the parasitic capacitance of the coaxial cable were effectively addressed. The experimental data within the span of 0–0.65 m from the explosive cartridge center show that there are two obvious peaks in the complete history of BWP, the first is a μs-level air shockwave load, followed by a ms-level explosion gas load. The peak of BWP is dominated by the peak of explosion gas ( P g ) within the scope of about 0–0.35 m from the explosive cartridge center, while is mainly determined by the peak of air shockwave ( P s ) in a farther range. The specific impulse distribution suggests that the explosion energy is mainly consumed in the area within the range of about 0–0.25 m from the explosive cartridge center. The strain rate in the borehole wall induced by air shockwave demonstrates a dynamic response (range of 131.9 ~ 2922.6 s −1 ), while indicating a quasi-dynamic loading (range of 0.1 ~ 2.1 s −1 ) when induced by the explosion gas. The findings contribute to expanding the understanding of the stress characteristics of the air shock wave and explosion gas and provide accurate initial loads for numerical simulation related to rock blasting of non-fluid–solid coupling.

Test and Analysis of Acceleration of Fuze in Bore

Analysis of the influence of different initial velocities on dynamic performance of multi-layer hard target penetration process

Simulation and Test of a MEMS Arming Device for a Fuze

Analysis and experiment of stress concentration in penetration fuze buffer materials under stress wave incursion

Study of failure mode and failure load of a civil aircraft pylon double-layer fuse pin

Test and Improvement of a Fuze MEMS Setback Arming Device Based on the EDM Process

Method of Determining the Critical Impact Velocity of Energetic Devices

The Design of the Acceleration Pulse Generator Based on the Metal Tubes Press Expansion

Measurement of Dynamic Fracture Parameters in the Expansion Process at High Strain Rate

Measurement of Dynamic Fracture Parameters of Explosive Cylindrical Shells

Advancements in research on high-overload impact-buffering protective materials

Structural Design of MEMS Acceleration Sensor Based on PZT Plate Capacitance Detection

Analysis of the Overpressure Fields in a Shock Tube with Multi-Point Initiation

Optimal Falling Track Design for Twice detonating Fuze of Double event Fuel air Explosive with High Speed

Numerical simulation of a shock wave experiment apparatus based on the air cannon

Measurement and Stress Response Analysis of Complete History of Blast-Induced Wall Pressure for Boreholes: A Case with Air-Deck Charge

Study of Multi-ranged Piezoresistive Micro Accelerometer Package Failure under High Overload

The research for characters of detonated rupture disks used in rarefaction wave gun for test

Study on Axial Dispersion Characteristics of Double-Layer Prefabricated Fragments

Blast wave characteristics of multi-layer composite charge: Theoretical analysis, numerical simulation, and experimental validation

Deformation and Failure of Polymer Bonded Explosives under Diametric Compression Test