Abstract:Thin-walled structures are widely used as typical high-efficiency energy-absorbing structures in crash safety protection. This paper aims to combine the characteristic of the square tube which concentrates energy dissipation through angle elements with the stable fold deformation of the circular tube, and innovatively propose a special-shaped thin-walled tube that contains both angle elements and arc elements. The failure behavior and energy absorption characteristics of the special-shaped tube were investigated by compression test and numerical simulation. The simulation results showed that the special-shaped thin-walled tubes have a significant advantage in energy absorption, and the specific energy absorption of the special-shaped tubes is 31.57% and 75.2% higher than that of the equal-mass circular and square tubes, respectively. Next, through finite element analysis, the effects of various parameters and initial imperfections on the crashworthiness of the special-shaped tubes were compared. The results indicated that adjustments to geometrical parameters significantly impact the energy absorption properties and crushing behavior of thin-walled tubes. Moreover, the tube with induced circular holes exhibited an optimal deformation mode. Further, a multi-objective optimal design of the metal special-shaped tube was carried out to obtain the best parameter configuration of the metal special-shaped tube. Finally, the special-shaped structure was extended to CFRP/AL hybrid thin-walled tubes. The failure behavior and energy absorption enhancement mechanism of the hybrid special-shaped tubes were investigated with experiments, and the absorbed energy of the hybrid tube was about 20% higher than the sum of the absorbed energy of the single constituent tubes. The effect of the CFRP lay-up pattern on the crashworthiness of the hybrid tube was investigated by numerical simulation, and it was found that the energy absorption capacity of the hybrid tube could be improved by appropriately increasing the number of layers and the proportion of axial fibers.

The Design of the Acceleration Pulse Generator Based on the Metal Tubes Press Expansion

Axial Impact Behaviors of Stub Concrete-Filled Square Steel Tubes

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

Flexural behavior of concrete-filled circular steel tubes under high-strain rate impact loading

A Theoretical Study of the Expansion Metal Tubes

Investigation on metal diaphragm of pulse separation device in dual-pulse solid rocket motor

Plastically Deformed Tubes Subjected to Mechanical Expansion Processes

Research on the Equivalent Impact Test Method for Different Pulse Widths Based on Micro-Electro-Mechanical System Devices

Behaviour of expansion tubes under impact load: Deformation mode and mechanical response

Plastic Deformation of Metal Tubes Subjected to Lateral Blast Loads

Mechanical Performance of Multi-Cell Thin-Walled Tubes under Static and Dynamic Axial Loading

High-Impact Dynamic Loading Method for Calibration of Triaxial Acceleration Sensors

Crashworthiness analysis and optimization design of special-shaped thin-walled tubes by experiments and numerical simulation

Influence of material properties and geometric parameters of an impact pair on contact acceleration during a low-velocity impact

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

Measurement of Dynamic Fracture Parameters in the Expansion Process at High Strain Rate

Analysis of the Overpressure Fields in a Shock Tube with Multi-Point Initiation

An Improved Two-Arcs Deformational Theoretical Model of the Expansion Tubes

Investigation of Burst Pressure of Flat-Scored Metal Diaphragms in Hypersonic Impulse Facilities

Finite element analysis of locally strengthened stainless-steel tube under lateral impact loading

Expansion of Sandwich Tubes With Metal Foam Core Under Axial Compression