Abstract:The applications envisioned for sensor networks require collaborative execution of a distributed task amongst a large set of sensor nodes. This is realized by exchanging messages that are time-stamped using the local clocks on the nodes. Therefore, time synchronization becomes an indispensable piece of infrastructure in such systems. We propose a design of synchronous clock using digital tune method. It combines the factor of traditional way of network time protocol (NTP) and clock data recovery (CDR) to generate a low power and high precision synchronous clock between nodes. It uses DAC and voltage-controlled oscillator (VCXO) to act as local variable clock source, and by exchanging sync frames it measures the transfer propagation and time offset of two nodes. With this information, a fast convergence algorithm like successive approximation makes the clocks match well fast. A digital synchronous clock (DSC) eliminates the need of continually communication between two devices, which is used in CDR, and shows much more accuracy synchronization than NTP. When the DSC is in fine tune state, only low overhead communications are needed to maintain the synchronization of the clocks. The results shows that DSC can make the frequency difference of two clocks reduce to as low as 0.1 ppm. Compare to the accuracy of normal crystal (50 ppm), it is 5´102 better. While it is used to generate a synchronous pulse, the synchronization error of the pulse is better than 180 ns (3s, the alarm time is about one second).

A Loss of Reference Clock Detect Circuit

A Clock Isolation Technique for Low Power SoC Design

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

Design of a High Precision Chip for Detecting Electric Arc

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

Novel design of reference voltage source integrated in LCoS chip

A Time Synchronization Mechanism and Algorithm Based on Phase Lock Loop

High-precision High-Sensitivity Clock Recovery Circuit for a Mobile Payment Application

Delay Compensation for Harmonics Detection Based on Synchronous Reference Frame Without Phase Lock Loop

Reference Clock Assessment Techniques for PCIe Gen5 and Beyond

Sigma-delta based clock recovery using on-chip PLL in FPGA

A Sinusoidal Reference Signal Based High Accuracy Timing Skew Mismatch Estimation Scheme for Time Interleaved ADC.

A Sinusoidal Power Clock Generation Circuit for Energy Recovery Logic

An improved Phase/Frequency Detector and a glitch-suppression charge pump design for PLL applications

A High Precision and Low Power Digital Synchronous Clock for Sensor Network

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 1/4-RATE LINEAR PHASE DETECTOR FOR HIGH SPEED PLL-BASED CLOCK AND DATA RECOVERY CIRCUIT

A Clock Synchronizer for Repeaterless Low Swing On-Chip Links

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A low-power 10Gb/s CMOS clock and data recovery circuit with a quarter-rate phase detector