Abstract:This paper proposes an all−digital calibration algorithm that utilizes a reference channel to suppress the timing mismatch in the Time−Interleaved Analog−to−Digital Converter (TIADC). The output of the reference channel is aligned with each sub−channel in turn, therefore enabling the simultaneous sampling and conversion of the same input signal. First, the statistical characteristics across the channels are employed for estimating the timing mismatch; then, by comparing the output difference between the reference channel and the sub−channels that are sampled simultaneously, the deviation of the derivator can be calibrated. Finally, combining both calibration results yields an accurate final output. This proposed algorithm provides an effective solution to improve TIADC performance in high−speed data acquisition systems. The proposed architecture is applied to a 12−bit 2.4 GS/s four−channel TIADC model, and then its effectiveness is verified. The simulation results exhibit that the Effective Number Of Bits (ENOB) at an input signal frequency of 984 MHz shows a remarkable improvement from 6.88 bits to 11.92 bits. The effectiveness of this technique is also demonstrated through the off−chip calibration of a commercial 12−bit four−channel 2 GS/s TIADC using a 680 MHz input signal that is based on the actual chip results.

Adaptive evaluation method for time-base mismatch of sampling systems

The fast time-interleaved ADC channel mismatch calibration method based on equivalent sampling and dynamic reference point

An Adaptive Blind Calibration Technique for Frequency Response Mismatches in M-Channel Time-Interleaved ADCs

Simple Approach to Determining Parameters of Noncommensurate Sampling for Optimal Pseudo-Noise Code Phase Delay Discrimination

A Wideband Timing Mismatch Calibration Design for Time-Interleaved Analog-to-Digital Converters with Fast Convergence

A Statistics-Based Background Timing Skew Calibration Algorithm For Time-Interleaved Adcs

A Novel Autocorrelation-Based Timing Mismatch C Alibration Strategy in Time-Interleaved ADCs

Novel Adaptive Blind Calibration Technique of Time-Skew Mismatches for Any Channel Time-Interleaved Analogue-to-digital Converters

Spectrum distribution‐based blind calibration method of mismatches for time‐interleaved ADCs

A Background Timing Skew Calibration Technique In Time-Interleaved Adcs

TI-ADC multi-channel mismatch estimation and calibration in ultra-high-speed optical signal acquisition system

An All-Digital Background Calibration Technique for M-Channel Downsampling Time-Interleaved ADCs Based on Interpolation

Study on Self-adaptive Calibration for Non-uniform Errors of ADC Parallel Sampling System

Two adaptive algorithms for multipath time delay estimation

A Sinusoidal Reference Signal Based High Accuracy Timing Skew Mismatch Estimation Scheme for Time Interleaved ADC.

A Channel and Carrier Frequency Offset Joint Estimation Algorithm for TD-SCDMA

An improved wide-range, low-complexity, fully-parallel digital background timing mismatch calibration method for dual-channel TIADC based on perfect reconstruction filter bank

An All−Digital Timing Mismatch Calibration Algorithm Based on Reference Channel for TIADC

Time- and Frequency-Interleaving: Distinctions and Connections

Time interleaved ADCs for high speed high resolution data acquisition system

A Mixed Sample-Time Error Calibration Technique in Time-Interleaved ADCs