Abstract:High-speed analog-to-digital conversion (ADC) is experimentally demonstrated by employing a time and wavelength interleaved ultra-short optical pulse train to achieve photonic sampling and using wavelength division demultiplexing to realize speed matching between the fast optical front-end and the slow electronic back-end. The sampling optical pulse train is generated from a cavity-less ultra-short optical pulse source involving a packaged device that monolithically integrates an intensity modulator and a phase modulator into a chip based on lithium niobate on insulator (LNOI). In the experiment, the fiber-to-fiber insertion loss of the packaged modulation device is measured to be 6.9 dB. In addition, the half-wave voltages of the Mach-Zehnder modulator and the phase modulator in the LNOI-based modulation device are measured to be 3.6 V and 3.4 V at 5 GHz, respectively. These parameters and the device size are superior to those based on cascaded commercial devices. Through using the packaged modulation device, two ultra-short optical pulse trains centered at 1541.40 nm and 1555.64 nm are generated with time jitters of 19.2 fs and 18.9 fs in the integral offset frequency range of 1 kHz to 10 MHz, respectively, and are perfectly time interleaved into a single pulse train with a repetition rate of 10 GHz and a time jitter of 19.8 fs. Based on the time and wavelength interleaved ultra-short optical pulse train, direct digitization of microwave signals within the frequency range of 1 GHz to 40 GHz is demonstrated by using a two-channel wavelength demultiplexing photonic ADC architecture, where the effective number of bits are 5.85 bits and 3.75 bits for the input signal at 1.1 GHz and 36.3 GHz, respectively.

A Novel High-Speed Optical Hold Module

Optimization Of Sample/Hold Circuit For High-Speed And High-Resolution Adcs

High-speed Optical Hold Module in Optical Assisted ADC

Incoherent Photonic Digital-To-Analogue Converter Based on Broadband Optical Source

Design of a High-Speed Sample-and-hold Circuit Using a Substrate-Biasing-effect Attenuated T Switch

Design of a Sample-and-Hold Circuit for High Speed CMOS Image Sensor

A Photonic Digital-to-analog Conversion Based on Multi-Wavelength Sampling

Photonic serial implementation of a flash analog-to-digital converter.

Photonic-Assisted Time-Interleaved Adc Based on Optical Delay Line

Optoelectronic Hybrid ADC Based on Time-Interleaved Multi-Wavelength Pulse Generation

High-speed compact silicon digital optical switch with slot structure

Photonic sampling analog-to-digital conversion based on time and wavelength interleaved ultra-short optical pulse train generated by using monolithic integrated LNOI intensity and phase modulator.

Optical Analog-to-Digital Conversion System Based on Compressive Sampling

Optical Assisted Digital-to-analog Conversion Using Dispersion-Based Wavelength Multiplexing

Experimental Demonstration of a Real-Time Hybrid Optoelectronic Analog-to-digital Converter

Differentially Encoded Photonic Analog-to-Digital Conversion Based on Phase Modulation and Interferometric Demodulation

Optical A/D Conversion

A Sub-Sampling Time-Interleaved Photonic Analog-to-Digital Converter Based on an Optoelectronic Oscillator

Modulator-Based High-Speed Optical Signal Processing For Optical Time-Division Multiplexing

Experimental Study on a 4-B Serial Optical Digital to Analog Convertor

A CMOS high performance 50MS/s sample/hold circuit