Abstract:Shot peening (SP) can modify the surface properties of titanium alloys and titanium matrix composites (TMCs). Based on our previous work in the last ten years, the microstructure and mechanical properties of SP treated Ti-6Al-4V (TC4) and (TiB+TiC)/TC4 are summarized in this review. The compressive residual stress (CRS) was formed on the surface after SP. At different SP intensities, the thickness of the surface CRS layer was improved with increasing SP intensities. During the stress peening, the CRS increased evidently, and the increment was proportional to the prestress. Besides, CRS's thermal relaxation was investigated, which showed that the CRS in the whole deformation layer was relaxed. The relaxation mechanism could be explained by the Zener-Wert-Avrami model. The microstrain, the domain size, and the dislocation density of the peened layer were investigated using the Voigt method. The domain size of TC4 was smaller than the composite, and the microstrain of the TC4 was higher than the composite. The average dislocation density was increased after SP due to the existence of reinforcements. Utilizing the Rietveld method to analyze the microstructure after SP, the variations were similar to the Voigt method's results. Also, the composite's stability was higher than TC4 because of the existence of reinforcements. Hardness analysis revealed that the existence of reinforcements raised the hardness. In the peened layer, the surface's hardness was maximum, and it decreased with the increase in depth. At the same temperature, the hardness of the TC4 was smaller than the composite counterpart. Finally, the strengthening mechanism of SP was discussed and summarized based on the above analysis.

Surface Layer Characteristics of TiB2/Al Composite by Stress Peening

Effect of Stress Peening on Surface Layer Characteristics of (tib + TiC)/Ti–6Al–4V Composite

Effect of shot peening on surface mechanical properties of TiB 2 /Al composite

Surface Layer Characteristics of CNT/Al–Mg–Si Alloy Composites Treated by Stress Peening

Investigation for warm peening of TiB2/Al composite using X-ray diffraction

The texture effect of warm peening on TiB2/Al composite

Investigation on the Residual Stress and Microstructure of (tib+tic)/ti–6al–4v Composite after Shot Peening

Residual Stress Relaxation in Shot Peened Surface Layer on Tib2/Al Composite under Applied Loading

Finite Element Simulation of Micro-region Residual Stress of Shot Peened TiB_2/Al Composite

XRD Investigation of Thermal Relaxation Behavior of Microstructure in TiB2/Al Deformation Layer Introduced by Shot Peening

Investigation on Microstructure and Properties of Al18B4O33 Whisker Reinforced AlMgSi Matrix Composite after Shot Peening

XRD Investigation of Thermostability of TiB2/Al Deformation Layer Introduced by Shot Peening

Residual Stress Distribution And Microstructure Characterization Of Particle Reinforced Titanium Matrix Composite After Shot Peening Treatment: A Review

Investigation for Different Peening Techniques on Residual Stress Field of SiCw/Al Composite

Investigation on the Surface Layer Characteristics of Shot Peened Titanium Matrix Composite Utilizing X-ray Diffraction

Thermal Relaxation of Residual Stresses in Shot Peened Surface Layer on Tib2/Al Composite at Elevated Temperatures

Microstructures of Shot Peened Layer on TiB2/AI at Elevated Temperatures

Thermal Relaxation of Residual Stress in Shot-Peened CNT/Al–Mg–Si Alloy Composites

Numerical Analysis and Experimental Validation on Residual Stress Distribution of Titanium Matrix Composite after Shot Peening Treatment

Experimental Investigation On Laser Peening Of Additively Manufactured Ti6al4v Alloy

Investigation on Surface Layers Characteristics of Pre-Stressed Shot Peening Inconel 625