Abstract:In scramjet engines, the optimal design of a regenerative cooling channel is critical for cooling, reducing pressure loss on the walls of the combustion chamber and improving heat sink utilization of fuel. In this study, thermal performance factor ( η ) and proportion of chemical heat sink in total heat sink ( ψ ) are introduced as objective functions, additionally, multi-objective optimizations are performed on a rectangular cooling channel using the DOE (design of experiments) method. Two suitable regression models for objective functions η and ψ are quantitatively generated by employing the RSM (response surface methodology), and the R-squared of the regression models are 98.34 % and 97.44 %, respectively. The precision and dependability of the models, as well as the degree of significance of the variables including the mass flow rate ( ṁ ), aspect ratio ( AR ), and wall thickness ( t w ) are assessed via the ANOVA (analysis of variance). The results show that the linear variables x 1 ( ṁ ) and interaction variable x 1 x 2 ( ṁ , AR ) are the most essential variables in forecasting η and ψ , respectively. The complex effects of linear and interactive variables on the objective functions are discussed. When the cracking rate is less than 40 %, the effect of x 1 ( ṁ ) on η initially decreases and then increases. By contrast, x 3 ( t w ) causes an increase in η initially, followed by a decrease. The variables affecting ψ are x 1 ( ṁ ), x 2 ( AR ), and x 3 ( t w ), in the descending order in terms of effect degree. In addition, to optimize η and ψ simultaneously (weight distribution is equal to one-half for both sides), an optimal point with ṁ = 378.89 g/s, AR = 1, and t w = 1.5 mm is introduced, which yields η = 0.898 and ψ = 0.505. The maximum error between the value fitted using the regression model and the value calculated from simulations is 3.03 %.

Optimized Design on a New Type Thermal Structure of Scramjet Combustor

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

Active Cooling Design on Heat Transfer Enhancement for Scramjet Engines Using Optimization Methods

Study of Heat Transfer of Composite Lattice Structure for Active Cooling Used in the Scramjet Combustor

Numerical Investigation on Cavity Structure of Solid-Fuel Scramjet Combustor

Experimental Study of the Configuration Optimization of Scramjet Combustor

Effects of Scramjet Combustor Configuration on Combustor Performance

Numerical investigation on regeneration-transpiration combined cooling of cavity structure in scramjet engine

Thermodynamic optimization for a scramjet with Re-cooled Cycle

Experimental study on the effect of combustor configuration on the performance of dual-mode combustor

Multi-objective Optimization Towards Cooling Performance of Teardrop Section Kagome Trusses Array Jet Impingement Composite Cooling Structure with Cross-Flow

Thermodynamic analysis on the performance of hydrocarbon fueled scramjet with inlet active cooling

Numerical Investigation on Internal Regressing Shapes of Solid-Fuel Scramjet Combustor

Progress of Coupled Heat Transfer Mechanisms of Regenerative Cooling System in a Scramjet

Multi-objective optimization of rectangular cooling channel design using Design of Experiments (DOE)

Control-oriented Modeling and Real-Time Simulation Method for a Dual-Mode Scramjet Combustor

Performance Analysis and Optimization of a Novel S-CO2 Closed-Brayton-cycle-based Thermal Management System for Scramjets

Thermodynamic Analysis and Parametric Study of a Closed Brayton Cycle Thermal Management System for Scramjet

Numerical Investigation on Performance of Axisymmetric Variable Geometry Scramjet Combustor Equipped with Strut Flame Holder

Optimization design method of integrated thermal protection/insulation composite material

Performance Evaluation of Fuel Indirect Cooling Based Thermal Management System Using Liquid Metal for Hydrocarbon-Fueled Scramjet