Abstract:In scramjet engines, the optimal design of a regenerative cooling channel is critical for cooling, reducing pressure loss on the walls of the combustion chamber and improving heat sink utilization of fuel. In this study, thermal performance factor ( η ) and proportion of chemical heat sink in total heat sink ( ψ ) are introduced as objective functions, additionally, multi-objective optimizations are performed on a rectangular cooling channel using the DOE (design of experiments) method. Two suitable regression models for objective functions η and ψ are quantitatively generated by employing the RSM (response surface methodology), and the R-squared of the regression models are 98.34 % and 97.44 %, respectively. The precision and dependability of the models, as well as the degree of significance of the variables including the mass flow rate ( ṁ ), aspect ratio ( AR ), and wall thickness ( t w ) are assessed via the ANOVA (analysis of variance). The results show that the linear variables x 1 ( ṁ ) and interaction variable x 1 x 2 ( ṁ , AR ) are the most essential variables in forecasting η and ψ , respectively. The complex effects of linear and interactive variables on the objective functions are discussed. When the cracking rate is less than 40 %, the effect of x 1 ( ṁ ) on η initially decreases and then increases. By contrast, x 3 ( t w ) causes an increase in η initially, followed by a decrease. The variables affecting ψ are x 1 ( ṁ ), x 2 ( AR ), and x 3 ( t w ), in the descending order in terms of effect degree. In addition, to optimize η and ψ simultaneously (weight distribution is equal to one-half for both sides), an optimal point with ṁ = 378.89 g/s, AR = 1, and t w = 1.5 mm is introduced, which yields η = 0.898 and ψ = 0.505. The maximum error between the value fitted using the regression model and the value calculated from simulations is 3.03 %.

Active Cooling Design on Heat Transfer Enhancement for Scramjet Engines Using Optimization Methods

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

Thermodynamic analysis on the performance of hydrocarbon fueled scramjet with inlet active cooling

Off-Design Condition Cooling Capacity Analysis of Recooling Cycle for A Scramjet

Thermal management method of fuel in advanced aeroengines

Parametric Study on the Distribution of Flow Rate and Heat Sink Utilization in Cooling Channels of Advanced Aero-Engines

Efficient utilization of heat sink of hydrocarbon fuel for regeneratively cooled scramjet

Parametric numerical analysis of regenerative cooling in hydrogen fueled scramjet engines

Parametric Study on the Hydrocarbon Fuel Flow Rate Distribution and Cooling Effect in Non-Uniformly Heated Parallel Cooling Channels

Multi-objective optimization of rectangular cooling channel design using Design of Experiments (DOE)

Thermodynamic optimization for a scramjet with Re-cooled Cycle

Multi-objective Optimization of Transpiration Cooling for High Pressure Turbine Vane

Thermodynamic Analysis and Parametric Study of a Closed Brayton Cycle Thermal Management System for Scramjet

Study of Heat Transfer of Composite Lattice Structure for Active Cooling Used in the Scramjet Combustor

Effect of Cooling Channel Geometry on Re-Cooled Cycle Performance for Hydrogen Fueled Scramjet

Performance Cycle Analysis of an Open Cooling Cycle for a Scramjet

Progress of Coupled Heat Transfer Mechanisms of Regenerative Cooling System in a Scramjet

Heat Transfer Characteristic Modelling and the Effect of Operating Conditions on Re-Cooled Cycle for A Scramjet

Study on Combined Thermal Protection Scheme Integrating Supercritical CO2 Regenerative Cooling and Fuel Film Cooling Used for Scramjet Engines

Design optimization and off-design performance analysis of axisymmetric scramjet intakes for ascent flight

Performance Analysis and Optimization of a Novel S-CO2 Closed-Brayton-cycle-based Thermal Management System for Scramjets