Abstract:Open-cell metal foams are a group of emerging porous materials with exceptionally large porosity that are becoming increasingly popular in a diverse range of applications such as heat exchanger and chemical reactors. However, the pressure drop characteristic of metal foam structure at high pore density remains largely unclear and unexplored. In this study, the permeabilities of 6 different copper foam samples with a pore density increasing from 35 to 130 PPI (the corresponding pore size decreases from 0.9 to 0.19 mm) were analyzed experimentally by forced convective flow test. The pressure drop characteristics were quantified by permeability and Forchheimer coefficient according to the linear Darcy equation and quadratic Forchheimer equation. The results show that increasing pore density from 35 to 95 PPI cause the permeability to drop by around 80%, the percentage difference between Darcy and Forchheimer permeability to reduce from 50% to 5%, and the average pore size based critical Reynolds number to decrease from 250 to 50. However, further increasing the pore density from 95 to 130 PPI has marginal effect on these parameters. Finally, the experimental data were benchmarked with a collection of literature data and empirical models to demonstrate the distinct flow behavior in metal foam at high pore density condition. The correlation proposed by X. Yang et al. provides the most accurate prediction of copper foam permeability at high PPI with a maximum error of less than 15%. These new findings provide important reference data to future studies on heat and mass transfer in metal foam structure for varies applications.

Preparation of high porosity copper foam by polyurethane sponge impregnation method

Copper Foam Preparation by Electrodeposition

Multifunctional Open-Cell Copper Foam with Sphere Pores by a Modified Sintering–Dissolution Process

Fabrication, Structure and Property of Copper Foam

Porous copper with capillary performance and gas permeability prepared by two-step foaming method

Microstructure of Ceramic Foams

Development Status and Preparation Technology of Copper Foams

Microstructure and Sound Absorption of Porous Copper Prepared by Resin Curing and Foaming Method

Fabrication and Characterization of Porous Copper with Ultrahigh Porosity

Effect of structural characteristics on the natural convective heat transfer performance of copper foam

A new sintering method for fabrication of open-cell metal foam parts

Experimental Study on Capillary Microflows in High Porosity Open-Cell Metal Foams

Study on the Compression Properties and Deformation Failure Mechanism of Open‐Cell Copper Foam

Effects of structure characteristics and fluid on the effective thermal conductivity of sintered copper foam

Interfacial microstructure and strength of brazed copper/porous copper foam towards the effect of porous copper foam pore density and brazing holding time

Preparation and Heat Dissipation Properties Comparison of Al and Cu Foam

Enhancing Wicking Microflows in Metallic Foams

Experimental investigation of permeability and Darcy-Forchheimer flow transition in metal foam with high pore density

Pore-scale Visualization and Measurement of Paraffin Solidification in High Porosity Open-Cell Copper Foam

Experimental Investigation on the Solidification Behavior of Phase Change Materials in Open-Cell Metal Foams

Preparation and Compression Behavior of High Porosity, Microporous Open-Cell Al Foam Using Supergravity Infiltration Method