Abstract:This work reports a new simulated inductor which is suitable for a Contactless Electrical Tomography (CET) system and can effectively overcome the unfavorable influence of coupling capacitance on the measurement results. By detailed analysis and comparison, it is found that the grounded simulated inductor has a simple circuit construction but its output current is not equal to its input current, while the floating simulated inductor can be used as an independent inductor module but its circuit structure is relatively complex. A new simulated inductor is designed by compensating the currents from the common node of an introduced independent power source to the main circuit. The new simulated inductor combines the advantages of the grounded simulated inductor and the floating simulated inductor. It has the simple construction similar to that of the grounded simulated inductor and its input current is equal to the output current, which means it can be used as an independent module. The impedance measurement and practical image reconstruction experiments were carried out to verify the effectiveness of the new simulated inductor. The experimental results show that the design of the new simulated inductor is successful, and the performance of the impedance measurement is satisfactory. The signal-to-noise ratio of the CET system is improved. Meanwhile, the research work also indicates that in the case when the independent power source is not available, the new simulated inductor is also an effective alternative method. But the phase difference between input signal and output signal is approximately 90° when the elimination principle is realized.

A New Embedded Helix-Type Inductor Using LTCC Technology for High Frequency Applications

The design and fabrication of LTCC chip inductors for high frequency applications based on barium ferrites

On the Design of a New Simulated Inductor Using a Contactless Electrical Tomography System As an Example

On-chip Vertical Tapered Solenoid Inductor with High Self-Resonance Frequency

A New Circuit Model of Helical Inductor Using LTCC Technology

A Novel Compact Model for On-Chip Vertically-Coiled Spiral Inductors

A Multilayer Power Inductor Fabricated by Cofirable Ceramic/Ferrite Materials with LTCC Technology

On-Chip Integrated Inductors with Ferrite Thin-Films for RF IC

On-Chip Integrated Inductors with Ni-Zn-Cu-Fe and Y-Bi-Fe Ferrite Thin-films for RF IC

MEMS-based Fabrication of High-Performance Inductors with Back Hollow Structure and Ferromagnetic Film

Fully Integrated Ferrite-Based Inductors for Rf Ics

Design of Multi-Turn LTCC Inductors for High Frequency DC/DC Converters

Magnetic film inductors for RF IC

Small-Resistance And High-Quality-Factor Magnetic Integrated Inductors On Pcb

Inductance and Q‐factor of micro‐magnetic inductor are enhanced by FeCoB films with self‐bias

Ni-Zn Ferrite Film Coated On-Chip Rf Inductor Fabricated by A Novel Powder-Mixed-Photoresist Coating Technique

Modelling On-Chip Circular Double-Spiral Stacked Inductors for RFICs

Ferrite-Partially-Filled On-Chip RF Inductor Fabricated Using Low-Temperature Nano-Powder-Mixed-Photoresist Filling Technique for Standard CMOS

Ni-Zn Ferrite-Powder-Mixed-Photoresist Coated On-Chip RF Inductor

On-Package Magnetic Materials For Embedded Inductor Applications

Design and Simulation of Embedded Inductor Based on Low Temperature Co-Fired Ceramic