Abstract:An experimental simulation study on the transition from pressurized to boiling operation of a low-temperature, natural circulation nuclear heating reactor (5 MW) developed by INET of Tsinghua University is presented. The experiment was performed on the test loop (HRTL-5), which simulates the geometry and system design of the 5 MW reactor. The manifestation of different kinds of two-phase flow instabilities, namely geysering, flashing instability and low-steam quality density wave instability on the transition from pressurized to boiling operation is described. The mechanism of flashing instability, which has never been studied well on this field, is especially interpreted. It is suggested that the start-up process, from initial condition to boiling operation condition, should consist of three steps: (1) increasing of initial pressure by means of a noncondensable gas (N2), which is a very effective method to eliminate geysering and flashing instability at lower pressure. (2) start-up of the reactor at this pressurized condition with a constant heat flux under the limited value of 9 = 0.15 MW ?m-2, which controls the exit temperature of the heated section below the one of net vapor generation, the low steam quality density wave oscillation can be avoided. (3) transition to a lower pressure, boiling operation. The method of transition with low-heat flux and low-inlet subcooling is proposed: at pressurized operation condition, by reducing the heat flux to its lowest level, releasing the noncondensable gas and increasing the heat flux gradually (dq/dt3 kW ?m- 2 ?min-1l) , during which the low-steam quality density wave oscillation can be be prevented from occurring, then the boiling operation condition can be achieved through adjusting the heat flux and inlet subcooling to their designed value. A stable transition from pressurized to boiling operation of the 5 MW reactor is achieved by careful selection of the thermohydraulic parameters.

Analysis on subsequent nuclear boiling and dry-out during the start-up of a two-phase CO2 mechanically pumped thermal control system

ANALYSIS ON SUBSEQUENT NUCLEAR BOILING AND DRY-OUT DURING THE START-UP OF A TWO-PHASE CO_2 MECHANICALLY PUMPED THERMAL CONTROL SYSTEM

Investigation of Carbon Dioxide Explosive Boiling in Single Evaporator of A Two-Phase Mechanically Pumped Thermal Control Loop

Experimental investigation on startup of a novel two-phase cooling loop

Start-up Investigation on a Dual-Evaporator MPCL System

Analysis on Relationship Between Superheat Phenomena and Startup Temperature for Two-phase Cooling System

Experimental investigation on a mechanically pumped two-phase cooling loop with dual-evaporator

Dynamic thermal analysis of startup process for minichannel evaporator

Experimental Investigation on Flow Behavior During Start-up of a Heating Reactor

Theoretical and Experimental Investigation on Characteristics of CO2 Mechanically Pumped Two Phase Cooling System

Investigation of Effects of Auxiliary Measures for Startup of Loop Heat Pipes

Study on Start-Up Characteristics of a Heat Pipe Cooled Reactor Coupled with a Supercritical CO2 Brayton Cycle

Experimental Study on the Heat Transfer Performance of Pump-assisted Capillary Phase-change Loop

CFD simulation on the operation characteristics of CO 2 two-phase thermosyphon loop

Experimental investigation of startup behaviors of a dual compensation chamber loop heat pipe with insufficient fluid inventory

Experiment on Two-phase Cooling System with Dual-Evaporator Driven by Mechanical Pump

Experimental study on the transient behaviors of mechanically pumped two-phase loop with a novel accumulator for thermal control of space camera payload

Experimental Study on the Dynamic Heat Transfer Characteristics of a Mechanically Pumped Two-phase Cooling Loop

Thermofluidic behavior of a 2-m nitrogen-charged cryogenic capillary pumped loop during its supercritical startup

Dynamic performance analysis on start-up of closed-loop pulsating heat pipes (CLPHPs)

Visual Investigation on Startup Characteristics of a Novel Loop Heat Pipe