Abstract:With the rapid increase in non-uniform heat generation of integrated power electronic devices, a two-phase thermosyphon loop (TPTL) with multiple evaporators is one of the promising cooling technologies to solve thermal problems with low energy consumption. However, instability, such as fluctuations in temperature and pressure, is more likely to occur due to an increase in the number of evaporators and non-uniform heat generation. In order to clarify the mechanism of non-uniform heating on instability, a TPTL with a horizontal parallel tube evaporator for cooling multiple heat sources is proposed and experimentally investigated. The transient characteristics during the startup process, temperature distribution, and heat transfer performance in steady-state are all compared under uniform and non-uniform heating conditions with the same total heat load. The results indicate that different non-uniform heat load patterns may exacerbate or inhibit the temperature overshoot phenomenon, and the evolution of operating pressure can be divided into three stages. The maximum temperature during the startup process can be reduced by 31.43 %, and startup time is shortened by 69.03 %. Besides, non-uniform heating has minimal influence on the average temperature of the evaporator but a significant impact on temperature uniformity. The maximum average temperature increases by 3.92 %, while the temperature standard deviation increases by 64.38 %. When a high heat load is applied both upstream and downstream of the lower tube, the overall heat transfer coefficient increases by 28.34 % compared with the uniform heating condition, reaching 3305 W.m(-2).degrees C-1. Moreover, under the same non-uniform heat load pattern, the temperature overshoot phenomenon is inhibited by increasing the total heat load, leading to a smoother temperature curve and a faster startup speed. However, this inhibition effect on the temperature overshoot phenomenon decreases as the heat load increases. In a steady-state, when the total heat load increases by 1.5 times, the average temperature of the evaporator increases by 14.28 %, while the thermal resistance reduces by 12.96 % on average.

Investigation of Effects of Auxiliary Measures for Startup of Loop Heat Pipes

Experimental investigation on startup of a novel two-phase cooling loop

Experimental Study on Start-Up Characteristics of Loop Heat Pipes

Experimental study on superheat phenomena of two-phase mechanically pumped cooling loop

Analysis on Relationship Between Superheat Phenomena and Startup Temperature for Two-phase Cooling System

Development and Test Results of A Dual Compensation Chamber Loop Heat Pipe

Experimental investigation of startup behaviors of a dual compensation chamber loop heat pipe with insufficient fluid inventory

Experimental Study on the Thermal Performance of a Dual Compensation Chamber Loop Heat Pipe with Dual Vapor and Condenser Lines

Investigation on Start-up Characteristic for Evaporator in a Capillary Loop with Phase Change

Experimental investigation on the start-up performance of a loop heat pipe with three flat disk evaporators combined

Experimental Study on the Dynamic Heat Transfer Characteristics of a Mechanically Pumped Two-phase Cooling Loop

Experimental Study on A Flat Loop Heat Pipe Coupling the Compensation Chamber and the Condenser

The Effect of Heating Power Distribution on the Startup Time and Overshoot of a Loop Thermosyphon with Dual Evaporators

Experimental Study on the Heat Transfer Performance of Pump-assisted Capillary Phase-change Loop

Improved Startup Performance of a Dual Compensation Chamber Loop Heat Pipe by Sequential Cooling to the Compensation Chambers

Analysis on subsequent nuclear boiling and dry-out during the start-up of a two-phase CO2 mechanically pumped thermal control system

Experimental Study of a Two-Phase Thermosyphon Loop with a Horizontal Parallel Tube Evaporator under Non-Uniform Heating Conditions

Experiment on Two-phase Cooling System with Dual-Evaporator Driven by Mechanical Pump

Experimental investigation on the start-up performance of a novel flat loop heat pipe with dual evaporators

Visual Investigation on Startup Characteristics of a Novel Loop Heat Pipe