Abstract:With the rapid increase in non-uniform heat generation of integrated power electronic devices, a two-phase thermosyphon loop (TPTL) with multiple evaporators is one of the promising cooling technologies to solve thermal problems with low energy consumption. However, instability, such as fluctuations in temperature and pressure, is more likely to occur due to an increase in the number of evaporators and non-uniform heat generation. In order to clarify the mechanism of non-uniform heating on instability, a TPTL with a horizontal parallel tube evaporator for cooling multiple heat sources is proposed and experimentally investigated. The transient characteristics during the startup process, temperature distribution, and heat transfer performance in steady-state are all compared under uniform and non-uniform heating conditions with the same total heat load. The results indicate that different non-uniform heat load patterns may exacerbate or inhibit the temperature overshoot phenomenon, and the evolution of operating pressure can be divided into three stages. The maximum temperature during the startup process can be reduced by 31.43 %, and startup time is shortened by 69.03 %. Besides, non-uniform heating has minimal influence on the average temperature of the evaporator but a significant impact on temperature uniformity. The maximum average temperature increases by 3.92 %, while the temperature standard deviation increases by 64.38 %. When a high heat load is applied both upstream and downstream of the lower tube, the overall heat transfer coefficient increases by 28.34 % compared with the uniform heating condition, reaching 3305 W.m(-2).degrees C-1. Moreover, under the same non-uniform heat load pattern, the temperature overshoot phenomenon is inhibited by increasing the total heat load, leading to a smoother temperature curve and a faster startup speed. However, this inhibition effect on the temperature overshoot phenomenon decreases as the heat load increases. In a steady-state, when the total heat load increases by 1.5 times, the average temperature of the evaporator increases by 14.28 %, while the thermal resistance reduces by 12.96 % on average.

Dynamic thermal analysis of startup process for minichannel evaporator

Startup Regimes of Minichannel Evaporator in a Mechanically Pumped Fluid Loop

Experimental investigation on startup of a novel two-phase cooling loop

Investigating the Thermal-Hydraulic Performance of New Refrigerant Mixtures Through Numerical Simulation of Minichannel and Microchannel Evaporators

Experimental Study on the Dynamic Heat Transfer Characteristics of a Mechanically Pumped Two-phase Cooling Loop

Investigation on Start-up Characteristic for Evaporator in a Capillary Loop with Phase Change

Start-up Investigation on a Dual-Evaporator MPCL System

Investigation on the Dynamic Thermal Response of Jet Evaporators to Short-Term Thermal Excitation

Dynamic performance analysis on start-up of closed-loop pulsating heat pipes (CLPHPs)

Experimental Study of a Two-Phase Thermosyphon Loop with a Horizontal Parallel Tube Evaporator under Non-Uniform Heating Conditions

Analysis on subsequent nuclear boiling and dry-out during the start-up of a two-phase CO2 mechanically pumped thermal control system

ANALYSIS ON SUBSEQUENT NUCLEAR BOILING AND DRY-OUT DURING THE START-UP OF A TWO-PHASE CO_2 MECHANICALLY PUMPED THERMAL CONTROL SYSTEM

Dynamic Response Characteristics of Microchannel Evaporator in a Mechanically Pumped Two-Phase Loop under Hypergravity Environment

Analysis on Relationship Between Superheat Phenomena and Startup Temperature for Two-phase Cooling System

Startup Characteristics of Pump-Assisted Capillary Phase Change Loop

Investigation of Carbon Dioxide Explosive Boiling in Single Evaporator of A Two-Phase Mechanically Pumped Thermal Control Loop

Experimental investigation of startup behaviors of a dual compensation chamber loop heat pipe with insufficient fluid inventory

Startup influencing factor investigation and quantitative interaction analysis on a loop thermosyphon with multiple evaporators

Experimental research on dynamic characteristics and control strategy of the pump-driven two-phase loop with dual evaporators

Startup Categories of Manifold Microchannel Heat Sink Heated by Thermal Test Chip

Investigation of Effects of Auxiliary Measures for Startup of Loop Heat Pipes