Abstract:The main failure mode of a wheel–axle assembly, which is an important moving part of rail vehicles, in the interference fit zone is partial fatigue. Given that neither the plane analytical method nor the axisymmetric finite element method can reveal the local and stochastic contact stress concentration at the end of the wheel seat, this study analyzed various factors influencing a machined mating surface and found that the cylindricity error is a key factor in transforming the plane contact into a 3D contact. In addition, the experimental data of the pressing force applied to 60 groups of wheel–axle assemblies were analyzed, and the circumferential contour of the mating surface was found to conform to a beta distribution. Accordingly, a method for obtaining random interpolation points on the circumferential contour was proposed. To ensure the continuity of the mating surface, the circumferential Hermite interpolation method and the axial cubic interpolation method were employed, and the contact surface with random characteristics was modeled. Based on the random ergodicity of the mating surface, a small-sample 3D finite element model of a wheel–axle assembly was established using the random cylindricity error, and a calculation method for the 3D contact stress was proposed. Taking the RE2B axle of railway locomotive as an example, compared with the axisymmetric method, the inhomogeneity analysis of the contact stress of the small-sample model proposed in this paper could help explain the problem of local stress concentration at the end of the wheel seat. The analysis results showed that the maximum stress of the 3D model based on the cylindricity is greater than that of the axisymmetric model, enabling strength evaluation in the design of wheel–axle assemblies.

Contact Stress Anslysis of Rotary-Support Component under Tractive Rolling Contact

Numerical Analysis of Rolling-Sliding Contact with Frictional Heating

Traction Formula for Rolling-Sliding Contacts in Consideration of Roughness under Low Slide to Roll Ratios

On the Elastic Stress Field of Tilting Roller Pairs Considering Thermal Elastohydrodynamic Lubrication

Analysis of Contact Deformations in Support Systems Using Roller Prisms

Three-dimensional contact surface modeling and stress analysis of interference fit based on cylindricity error

Contact Fatigue Life Analysis Of Rotary Kiln Roller

Finite Element Analysis of Contact Stresses on the Backup Roll of CVC Hot Rolling Mills

Analytical Solution for Sliding Rounded-Edge Contact

Multi-Condition Contact Stress Analysis of High Speed Train Helical Gear

A Numerical Solution For Fretting Contacts

Stress Analysis on Layered Materials in Point Elastohydrodynamic-Lubricated Contacts

Contact Analysis for Short Harmonic Reducer in Robotic Joints

The Finite Element Analysis for Supporting Wheel Deflection's Contact of Large-scale Rotary Kiln With Multi-supporting

Analysis of the Rolling Interface Contact Characteristics in Mixed Lubrication Based on Gaussian Distribution Theory

Numerical Simulation on the Stress Distribution of High Speed Angular Contact Rolling Bearing

Numberical Analysis on the Steady-State Rolling of Load-Carrying Tire

Contact Analysis of Abrasive Wear

Numerical And Experimental Investigation On The Controlling For Rotor-To-Stationary Part Rubbing In Rotating Machinery

Study on Subsurface Stress of Tilting Roller Considering EHL Effect

Modelling Tangential Contact Problem with Surface Stress