Abstract:Various generations of scholars have proposed many material removal models for grinding processing. However, the stress conditions of the free surface and regular surface are different. The free-form models will encounter problems in practical application. To refine the stress distribution in the contact area during grinding, it is necessary to construct the elastic contact model for the workpiece profile. This paper uses dimensional reduction to introduce the double curvatures to approximate the varying curvatures of the free surface. So, the conclusions of classical elastic Hertz contacting theory can be applied to the model. We use differential thought to deduce the relation between the normal force and the maximum deformation depth of the contact region. Then, we obtain the boundary of the contact region. After dimensional reduction by Winkler theory, we propose the normal equivalent spring potential energy correction error terms. They compensate for the local stress based on the relationship between stress and deformation of continuous media. According to the boundary of the contact region obtained above, we carry out the differential stress distribution. This accounts for the dispersion effect of the convex surface on the force. Using stress-indicating film to show the local stress distribution, the results revealed that the stress distribution was consistent with that of the simulated contact stress distribution. The error was controlled within 0.078MPa. To verify the practicality of the contact model in grinding experiments, we derived the theoretical grinding depth by combining the Hammann linear grinding model. This paper compares the experimental results with the model results. It demonstrates the proposed algorithm's superior adaptability and practical application ability to the free surface.

Contact Analysis for Short Harmonic Reducer in Robotic Joints

Deformation and stress analysis of short flexspline in the harmonic drive system with load

Optimization and Experimental Research on a New-Type Short Cylindrical Cup-Shaped Harmonic Reducer

Deformation of Harmonic Drive in Transmission State Based on Contact Analysis with Shell Element Tooth

Analysis of the Partial Axial Load of a Very Thin-Walled Spur-Gear (Flexspline) of a Harmonic Drive

Non-circular Interference Fit Analysis in Harmonic Reducer Based on Sequential Assembling and Loading Simulation

Research on torsional stiffness of flexspline-flexible bearing contact pair in harmonic drive based on macro-micro scale modeling

Piecewise approximation and local differential compensation of contact stress distribution of workpiece surface in robotic belt grinding

Contact analysis and strength calculations of involute spline couplings

Finite element modeling method of joint surfaces based on real surface pressure distribution

Neutral Line Stretch of Flexspline in Harmonic Driver

Local Mesh Refinement and Coarsening Based on Analysis-Suitable T-Splines Surface and Its Application in Contact Problem

Analysis and Modeling for Flexible Joint Interfaces under Micro and Macro Scale

Contact Stiffness of Rough Mechanical Joint Surface

Load Analysis Of Flexible Ball Bearing In A Harmonic Reducer

Modeling and Fatigue Characteristic Analysis of the Gear Flexspline of a Harmonic Reducer

Hybrid Finite Element Modeling of Subsurface-Originated Spalling in Flexible Bearings with Hoop Stresses

Effects Of Mechanical Flexibility And Clearance Size On The Wear At Revolute Joint In The Flexible Multibody Systems

Research on Spatial Developable Mechanism Considering Revolute Clearance Joints with Irregular Rough Surfaces

Investigation of an Improved Planar Revolute Clearance Joint Contact Model with Rough Surface

Deformation Analysis of the Flexspline of Harmonic Drive Gears Considering the Driving Speed Effect Using Laser Sensors