Abstract:Modified two-surface model (M2SM) is one of the steel elasto-plastic hysteretic constitutive models that consider both analysis accuracy and efficiency. However, when M2SM is used for complex strain history, sometimes the results are irrational due to the limitation of stress-strain path judgment. In this paper, the defect of M2SM was re-modified by improving the judgment of stress-strain paths. The accuracy and applicability of the improved method were verified on both material and structural level. Based on this improvement, the nonlinear time-history analysis was carried out for a deck-through steel arch bridge with a 200 m-long span under the ground motions of Chi-Chi earthquake and Niigata earthquake. In the analysis, we compared the results obtained by hysteretic constitutive models of improved two-surface model (I2SM) presented in this paper, M2SM and the bilinear kinematic hardening model (BKHM). Results show that, although the analysis precision of displacement response of different steel hysteretic models differs little from each other, the stress-strain responses of the structure are affected by steel hysteretic models apparently. The difference between the stress- strain responses obtained by I2SM and M2SM cannot be neglected. In significantly damaged areas, BKHM gives smaller stress result and obviously different strain response compared with I2SM and M2SM, and tends to overestimate the effect of hysteretic energy dissipation. Moreover, at some position with severe damage, BKHM may underestimate the size of seismic damaged areas. Different steel hysteretic models also have influences on structural damage evaluation results based on deformation behavior and low cycle fatigue, and may lead to completely different judgment of failure, especially in severely damaged areas.

Highway bridge unseating and reduction analysis using SMA restrainers under earthquake excitations

Experimental study of a highway bridge with shape memory alloy restrainers focusing on the mitigation of unseating and pounding

Effect of Hysteretic Constitutive Models on Elasto-Plastic Seismic Performance Evaluation of Steel Arch Bridges

Seismic Performance Assessment of a Multispan Continuous Isolated Highway Bridge with Superelastic Shape Memory Alloy Reinforced Piers and Restraining Devices

An Analysis of Pounding Mitigation and Stress Waves in Highway Bridges with Shape Memory Alloy Pseudo-Rubber Shock-Absorbing Devices

Sensitivity Analysis and Multi-Criteria Optimization of SMA Cable Restrainers for Longitudinal Seismic Protection of Isolated Simply Supported Highway Bridges

Pounding-Induced Stress Wave Analysis and Mitigation of Highway Bridges Under Earthquakes

Experimental and Analytical Study on Pounding Reduction of Base‐isolated Highway Bridges Using MR Dampers

Point-To-Surface Pounding of Highway Bridges with Deck Rotation Subjected to Bi-Directional Earthquake Excitations

3d Impact Model Of Highway Bridge During Seismic Events

Seismic performance of bridges with novel SMA cable‐restrained high damping rubber bearings against near‐fault ground motions

Seismic Cable Restrainer Design Method To Control The Large-Displacement Response For Multi-Span Simply Supported Bridges Crossing Fault Rupture Zones

Dynamic and Mitigation Analysis of Seismic Pounding Effect on Multi-Span Highway Bridges Subjected to Spatial Earthquakes

Pounding Reduction of Highway Bridges with Pounding Effect by Using Magnetorheological Dampers Under Earthquake Excitations

Pounding analysis methods and control of highway bridges under seismic excitations

Semi-Active Control Of Highway Bridges With Pounding Effect By Using Magnetorheological Dampers Under Earthquake Excitations - Art. No. 642310

Efficient seismic fragility assessment method for frictional isolated bridge constrained by shape memory alloy cables under pulse-like ground motions

Performance-based assessment of bridges with steel-SMA reinforced piers in a life-cycle context by numerical approach

Utilizing a new self-centering hysteresis model to assess the seismic vulnerability of a long-span cable-stayed bridge equipped with SMA wire-based roller bearings

Simplified linear analysis model of longitudinal constraint effect of high-speed railway simply-supported bridge under frequent earthquake

Seismic resilience of RC bridge with self-centering energy dissipation braces using SMA U-shaped plates