Abstract:Nanoporous gold (NPG) made by dealloying takes the form of a network of nanoscale struts or "ligaments". It is well established that the material's mechanical behavior is strongly affected by its ligament size, <math>L</math>, and by its solid volume fraction, <math>φ</math>. We explore the mechanical behavior of NPG, with an emphasis on establishing a consistent data set with comparable <math>L</math> but covering a significant range of initial <math>φ</math>. Specimens are prepared from Ag-Au master alloys with their Au atom fraction, <math>xAu0</math>, in the range 0.20 - 0.35. Since dealloying replaces Ag with voids, <math>φ</math> may be expected to agree with <math>xAu0</math>. Yet, spontaneous plastic deformation events during dealloying can result in macroscopic shrinkage, decoupling <math>φ</math> from <math>xAu0</math>. This raises the question, how do <math>φ</math> and <math>xAu0</math> separately affect the mechanical behavior? We confirm two recent suggestions, namely i) a modified Roberts-Garboczi-type scaling law for Young's modulus versus <math>φ</math> of the material in its as-prepared state and ii) the relevance of an apparent "load-bearing solid fraction" for Young's modulus as well as strength. Yet, remarkably, we find that stiffness and strength of the as-prepared material show a much better correlation to <math>xAu0</math> as compared to <math>φ</math>. This can be understood as a consequence of the microstructural changes induced by shrinkage. Studying the microstructure evolution during annealing, we also confirm the suggestion that coarsening entails an enhanced loss in stiffness for samples with lesser solid fraction. This finding confirms concerns about the notion of self-similar coarsening as a general behavior of dealloying-made network materials.

Determination of ligament size distribution of nanoporous gold by scanning electron microscopy and image analysis.

The ligament-size effect to the coefficient of thermal expansion for nanoporous gold: A molecular dynamics simulation study

Pore and Ligament Size Control, Thermal Stability and Mechanical Properties of Nanoporous Single Crystals of Gold

Mechanical Properties and Scaling Laws of Nanoporous Gold

On factors defining the mechanical behavior of nanoporous gold

Transition from Homogeneous to Localized Deformation in Nanoporous Gold

Plastic Deformation in Nanoscale Gold Single Crystals and Open-Celled Nanoporous Gold

Time-resolved Atomic-Scale Observations of Deformation and Fracture of Nanoporous Gold under Tension

Size dependent photoemission study by electrochemical coarsening of nanoporous gold

Stiffening of nanoporous Au as a result of dislocation density increase upon characteristic length reduction

Comparative STM studies of mixed ligand monolayers on gold nanoparticles in air and in 1-phenyloctane

Microfabrication and Mechanical Properties of Nanoporous Gold at the Nanoscale

Affinity of Ligands Co-Ordinated on Gold Nanoparticles

Correlative Extinction and Single Fluorophore Bleaching Microscopy for Ligand Quantification on Gold Nanoparticles

Atomic scale visualizations of low-angle grain boundary mediated plasticity by coupled dislocation climb and glide in nanoporous gold

Atomistic simulation of the effect of porosity on shock response of nanoporous gold

Strengthening Modulus and Softening Strength of Nanoporous Gold in Multiaxial Tension: Insights from Molecular Dynamics

Influence of mechanical compliance of the substrate on the morphology of nanoporous gold thin films

Automatic pore size measurements from scanning electron microscopy images of porous scaffolds

The Effect of Ligand Composition on the in Vivo Fate of Multidentate Poly(Ethylene Glycol) Modified Gold Nanoparticles

A critical relative density and a break-and-reconnect model for annealing-induced densification in nanoporous gold