Abstract:Nanoporous gold (NPG) made by dealloying takes the form of a network of nanoscale struts or "ligaments". It is well established that the material's mechanical behavior is strongly affected by its ligament size, <math>L</math>, and by its solid volume fraction, <math>φ</math>. We explore the mechanical behavior of NPG, with an emphasis on establishing a consistent data set with comparable <math>L</math> but covering a significant range of initial <math>φ</math>. Specimens are prepared from Ag-Au master alloys with their Au atom fraction, <math>xAu0</math>, in the range 0.20 - 0.35. Since dealloying replaces Ag with voids, <math>φ</math> may be expected to agree with <math>xAu0</math>. Yet, spontaneous plastic deformation events during dealloying can result in macroscopic shrinkage, decoupling <math>φ</math> from <math>xAu0</math>. This raises the question, how do <math>φ</math> and <math>xAu0</math> separately affect the mechanical behavior? We confirm two recent suggestions, namely i) a modified Roberts-Garboczi-type scaling law for Young's modulus versus <math>φ</math> of the material in its as-prepared state and ii) the relevance of an apparent "load-bearing solid fraction" for Young's modulus as well as strength. Yet, remarkably, we find that stiffness and strength of the as-prepared material show a much better correlation to <math>xAu0</math> as compared to <math>φ</math>. This can be understood as a consequence of the microstructural changes induced by shrinkage. Studying the microstructure evolution during annealing, we also confirm the suggestion that coarsening entails an enhanced loss in stiffness for samples with lesser solid fraction. This finding confirms concerns about the notion of self-similar coarsening as a general behavior of dealloying-made network materials.

Transition from Homogeneous to Localized Deformation in Nanoporous Gold

Plastic Deformation in Nanoscale Gold Single Crystals and Open-Celled Nanoporous Gold

A critical relative density and a break-and-reconnect model for annealing-induced densification in nanoporous gold

Nanopores in Nanocrystalline Gold

Mechanical Properties and Scaling Laws of Nanoporous Gold

On factors defining the mechanical behavior of nanoporous gold

Mechanical properties of unidirectional nanoporous gold under compression

High Resolution Transmission Electron Microscopic In-Situ Observations Of Plastic Deformation Of Compressed Nanocrystalline Gold

Effect of Lattice Defects on the Plastic Poisson's Ratio of Nanoporous Gold

Time-resolved Atomic-Scale Observations of Deformation and Fracture of Nanoporous Gold under Tension

Nanocrystalline gold with small size: inverse Hall-Petch between mixed regime and super-soft regime

Stiffening of nanoporous Au as a result of dislocation density increase upon characteristic length reduction

Competitive Effect of Disorder and Defects on Dynamic Structural Transformation of Compressed Gold

The ligament-size effect to the coefficient of thermal expansion for nanoporous gold: A molecular dynamics simulation study

Strengthening Modulus and Softening Strength of Nanoporous Gold in Multiaxial Tension: Insights from Molecular Dynamics

The Competitive Mechanism of Defects and Disorders on Dynamic Structural Transformation of Compressed Gold

Microfabrication and Mechanical Properties of Nanoporous Gold at the Nanoscale

Pristine-To-Pristine Regime of Plastic Deformation in Submicron-Sized Single Crystal Gold Particles

Atomic scale visualizations of low-angle grain boundary mediated plasticity by coupled dislocation climb and glide in nanoporous gold

Deformation of Solids with Nanoscale Pores by the Action of Capillary Forces

Study on the Microscopic Compression Deformation Mechanism of Nanocrystalline Single-Phase Gold Platinum Alloy