Co-hydrotreating of Algae and Used Engine Oil for the Direct Production of Gasoline and Diesel Fuels or Blending Components
Bing Wang,Pei-Gao Duan,Yu-Ping Xu,Feng Wang,Xian-Lei Shi,Jie Fu,Xiu-Yang Lu
DOI: https://doi.org/10.1016/j.energy.2016.03.084
IF: 9
2016-01-01
Energy
Abstract:Co-hydrotreating of microalgae (M) and UEO (used engine oil) was examined for the direct production of gasoline and diesel fuels or blending components. The addition of the noble metal catalysts promoted the cracking and in situ hydrogenation of liquid products (oils) and was beneficial for the production of liquid products. Usihg Pt/C as the catalyst, the effects of temperature (350-450 degrees C), time (2-6 h), UEO/M mass ratio (6/0-0/6), catalyst loading (1-60 wt.%), and initial H-2 pressure (0.1-8 MPa) on the yield and quality of the liquid products were studied. A synergistic effect existed during the co-hydrotreating of the UEO and microalgae, which not only favored the production of liquid products but also promoted in situ denitrogenation and deoxygenation. Co-hydrotreating produced an upgraded oil with fuel properties (e.g., density, calorific value) comparable to traditional liquid transportation fuels derived from fossil fuel. The S content (45 ppm) of the upgraded oil produced at 450 degrees C is even below the minimum requirement of China IV diesel (50 ppm). Examination of the composition of the upgraded oils showed the formation of dominant light aliphatic and aromatic hydrocarbons that could also be used as a chemical feedstock. (C) 2016 Elsevier Ltd. All rights reserved.