Abstract:The need for cleaner fuels has resulted in a continuing worldwide trend to reduce diesel sulfur and aromatics. There are many approaches to reducing sulfur and aromatics in diesel. Most of them have a common drawback of high cost because of adopting two stages of hydrotreating and using noble-metal catalyst, especially for reducing aromatics. The attempt to resolve this issue has led to the recent development of the Single Stage Hydrotreating (SSHT) process by Research Institute of Petroleum Processing (RIPP), SINOPEC.The SSHT process is a single-stage hydrotreating technology for producing low sulfur and low aromatics diesel. The process uses one or two non-noble-metal catalysts system and operates at moderate pressure. When revamping an existing unit to meet low aromatics diesel specification, the only thing to do is to add a reactor or replace the existing reactor, In pilot plant tests, the SSHT technology has successfully treated SRGO (Straight Run Gas Oil), LCO (Light Cycle Oil) or the blend of them. It is shown that by using the SSHT process diesel with sulfur of 30 ppm and aromatics of 15 m% can be produced from Middle-East SRGO and diesel with aromatics content of 25 m% can be produced from cracked feed, such as FCC-LCO. High diesel yield and cetane number gain (from cracked feed stocks) give the SSHT technology a performance advantage compared to conventional hydrocracking and hydrotreating processes.The lower investment and operating cost is another advantage. The first commercial application of the SSHT technology has been in operation since September 2001.

HYDROGENATION TECHNOLOGIES DEVELOPED BY RESEARCH INSTITUTE OF PETROLEUM PROCESSING FOR CLEAN FUEL PRODUCTION

Co-hydrotreating of Algae and Used Engine Oil for the Direct Production of Gasoline and Diesel Fuels or Blending Components

Crude Benzol Coking Products and Development of Its Hydro-Refining Technology

Crucial technologies supporting future development of petroleum refining industry

HYDROGENATION TECHNOLOGIES FOR PRODUCTION OF CLEAN GASOLINE AND DIESEL FUEL IN RIPP

Co-hydrotreating of Used Engine Oil and the Low-Boiling Fraction of Bio-Oil Blends for the Production of Liquid Fuel

HYDROGENATION CATALYST AND TECHNOLOGY IN PETROLEUM PROCESSING

PETROLEUM REFINING TECHNOLOGIES AND CATALYSIS IN THE 21~(st) CENTURY

TECHNICAL PROGRESS IN HYDRODESULFURIZATION

Developmet and application of fcc feed hydrotreating technology in ripp

DEVELOPMENT AND COMMERCIAL APPLICATION OF KEY TECHNOLOGY FOR EFFICIENT CONVERSION OF HEAVY OIL

SSHT Process-a Low Cost Solution for Low Sulfur and Low Aromatics Diesel

Improving Refinery Profits Via Fine Management of Hydrogen Networks

Process Optimization of RTS Technology for Ultra-Low Sulfur Diesel

Design of Hydrogen Enriched Compressed Natural Gas Engine Fuel System and Test Research

EVALUATION AND INDUSTRIAL APPLICATION OF PRE-HYDROTREATING CATALYST FOR REFORMING UNIT

Progress of Study on Hydrogen Production by Reformings of Hydrocarbons and Alcohols

Low-Temperature Hydrotreatment of C4/C5 Fractions Using a Dual-Metal-Loaded Composite Oxide Catalyst

Development and Commercial Application of High Efficiency Catalysts for Resid Hydrotreating

High-purity hydrogen production by sorption-enhanced steam reforming of iso-octane over a Pd-promoted Ni-Ca-Al-O bi-functional catalyst

Development of New Generation Catalysts for Selective Hydrodesulfurization of Fcc Naphtha