Abstract:Single-stage hydrotreating (HDT) of loblolly pine biocrude produced from catalytic pyrolysis was conducted to gain insight to HDT performance in terms of product yields, liquid product quality, and hydrogen consumption. Tests were performed with a sulfided HDT catalyst at three different conditions. The longest continuous time onstream operation (365 h) was achieved at an average bed temperature of 290 degrees C, 138 bar pressure, H2/oil ratio of 3300 Nl l(-1), and a liquid hourly space velocity (LHSV) of 0.25 h(-1). The average carbon yield of the HDT liquids were 77%, 83%, and 89% for experiments 1, 2, and 3, respectively. Also, the biocrude carbon that ended up in the gas phase varied between 4.3% and 8.9%. The carbon in the aqueous phase fraction was negligible-less than 0.5% of the biocrude carbon. The average hydrogen consumed ranged from 0.04 g to 0.07 g per 1 g of dry biocrude. The highest carbon content measured for the HDT liquid products from all three experiments was 87.13 wt% and the lowest was 79.03 wt%. GC-MS analysis suggests that the HDT product with oxygen content less than 5 wt% contained mainly naphthenic hydrocarbons. On the other hand, HDT products with oxygen content greater than 5 wt% contained a higher concentration of simple phenols and aromatic hydrocarbons (mono-and poly-). Catalyst deactivation was evident in the quality of the HDT liquid collected over time; the density and viscosity increased, the H/C ratio and carbon contents decreased; also, the gasoline fraction decreased while the gas oil fraction increased. The results from this work suggest that HDT of biocrude produced by catalytic biomass pyrolysis can be successfully upgraded into hydrocarbon liquid fuels without a stabilization step.

Development and commercial application of catalysts for resid hydrotreating technology (RHT)

Development and Commercial Application of High Efficiency Catalysts for Resid Hydrotreating

DEVELOPMENT AND COMMERCIAL APPLICATION OF KEY TECHNOLOGY FOR EFFICIENT CONVERSION OF HEAVY OIL

Co-hydrotreating of Algae and Used Engine Oil for the Direct Production of Gasoline and Diesel Fuels or Blending Components

Comparative Study on Hydrotreating of Venezuela De-Asphalted Oil: Conversion Behavior of Heteroatom Compounds and HDM Catalyst Deactivation

Development and progress of hydrogenation catalyst series

Co-hydrotreating of Used Engine Oil and the Low-Boiling Fraction of Bio-Oil Blends for the Production of Liquid Fuel

Ex-situ Presulfiding of Hydrotreating Catalysts

EVALUATION AND INDUSTRIAL APPLICATION OF PRE-HYDROTREATING CATALYST FOR REFORMING UNIT

A new generation hydrotreating catalyst RN-10

Development of New Generation Catalysts for Selective Hydrodesulfurization of Fcc Naphtha

A NEW GENERATION CATALYST RN 10 FOR DISTILLATE HYDROTREATING

PROGRESS OF HYDROCRACKING TECHNOLOGY IN RIPP

HYDROGENATION CATALYST AND TECHNOLOGY IN PETROLEUM PROCESSING

SSHT Process-a Low Cost Solution for Low Sulfur and Low Aromatics Diesel

Heavy oil atmospheric residue: HDS performance and life test using ARDS catalysts system

Developmet and application of fcc feed hydrotreating technology in ripp

Research and Development of Petroleum Hydrodesulfurization Catalysts with Al2O3-based Supports

Integration of catalytic fast pyrolysis and hydroprocessing: a pathway to refinery intermediates and “drop-in” fuels from biomass

Low-Temperature Hydrotreatment of C4/C5 Fractions Using a Dual-Metal-Loaded Composite Oxide Catalyst

Unraveling the Molecular-Level Structures and Distribution of Refractory Sulfur Compounds During Residue Hydrotreating Process