Abstract:Integration technology of residue hydrotreating (RHT) and delayed coking (DC) was first proven to be an effective strategy to process high-sulfur residue oil while reducing the coke yield and simultaneously controlling the sulfur content of coke. Then, the evolution of sulfur species in the integration process was investigated by XPS, online TG-MS analysis, and atmospheric pressure photoionization FT-ICR MS. Finally, the essential effects of the RHT process on sulfur evolution were evaluated. The RHT process optimized the conversion of the refractory thiophenic sulfurs into sulfidic sulfurs as indicated by the increasing abundance of sulfidic sulfur during RHT, which thereby helped to reduce the sulfur content in coke. Moreover, RHT promoted the saturation of condensed-aromatic-ring structures of some refractory thiophenic sulfurs and thus promoted the thermal cracking of these sulfurs, and the resulting sulfurs with a smaller size thereupon directly evaporate into the liquid products, thus further reducing the sulfur content in coke.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.iecr.0c02036.Table S1: properties of the residue feedstock of Fujian Refinery (FJAR) and its RHT products, Table S2: physical properties and compositions of the two hydrotreating catalysts used in the RHT-DC integration process, Table S3: comparison data about the products' yield distribution and coke content in coke between RHT-DC and other applied technology, Table S4: quantitative analysis results about the sulfur evolution during the RHT-DC integration process, Table S5: properties of the hydrotreated residue obtained at different hydrogen pressure, Figure S1: representative structures of thiophenic sulfurs and sulfidic sulfurs, and Figure S2: experimental value versus predicted value of the content of the three kinds of sulfur species during the RHT process through varying LHSVs (PDF)This article has not yet been cited by other publications.

A NEW INTEGRATION PROCESS OF RESIDUE HYDROTREATING COMBINED WITH CATALYTIC CRACKING

Study on Application of Bi-Directional Combination Technology Integrating Residue Hydrotreating with Catalytic Cracking Ricp

Developmet and application of fcc feed hydrotreating technology in ripp

New breakthrough of heavy oil upgrading technology - Integration processes of VRFCC/RMC for production of high value products and steam cracking feed

An Insight into the Evolution of Sulfur Species during the Integration Process of Residue Hydrotreating and Delayed Coking

DEVELOPMENT AND COMMERCIAL APPLICATION OF KEY TECHNOLOGY FOR EFFICIENT CONVERSION OF HEAVY OIL

PROGRESS OF HYDROCRACKING TECHNOLOGY IN RIPP

Deep Conversion of Venezuela Heavy Oil via Integrated Cracking and Coke Gasification–Combustion Process

Improvement of Residue by Hydrocracking with Solid Acid,solid Base and Radical Initiators

Study on the FCC process of a novel riser-downer coupling reactor (III): Industrial trial and-CFD modeling

RICH®-II technology for improving cetane number of FCC-LCO

Integration of catalytic fast pyrolysis and hydroprocessing: a pathway to refinery intermediates and “drop-in” fuels from biomass

Hydrocracking of vacuum residue in a slurry phase reactor: effect of reaction temperature and properties of feedstock

System integration and evaluation of residual oil deep catalytic cracking process coupled with CO 2 recycle to produce polypropyl carbonate

Downer-to-riser coupling technique for heavy oil catalytic cracking

Impact of Coprocessing Biocrude with Petroleum Stream on Hydrotreating Catalyst Stability

Synergism Between Hydrogen Donors and Dispersed Catalysts in Hydrocracking of Residue

Synergism of Hydrogen Donors and Dispersed Catalysts on Conversion of Different Residues

DEVELOPMENT OF MID-PRESSURE HYDROCRACKING FOR MORE MIDDLE DISTILLATES

Integration of CGO hydrotreatment with FCC

Downer-to-Riser Coupling Technique for Petroleum Refining