Abstract:Chemical looping reforming (CLR) with biomass pyrolysis oil (BPO) for syngas production was investigated using NiO/dolomite as the bed material which was prepared by the wet impregnation method. The NiO/dolomite was used as catalyst and oxygen carrier in the whole temperature range, while it was also acted as in-situ CO2 sorbent at 600 °C and 700 °C. The syngas production was dominated by the sorption enhanced and catalytic reforming of BPO, due to the formation of NiO–MgO solid solution, which had a lower reducibility at low temperatures. Although, the low level CGE at low temperature could be improved by elevating the oxygen coefficient at the certain extent, poor cyclic performance of NiO/dolomite at 700 °C was observed, owning to the sintering and agglomeration during the repeated carbonation/calcination reactions. High temperatures inhibited the carbonation reaction and facilitated the reduction of NiO–MgO solid solution to provide more lattice oxygen and catalytic active sites. The syngas production was governed by the synergistic effect of lattice oxygen and catalysis at high temperatures. The optimum operating condition for syngas production in CLR was obtained by the analysis showed as follows: the temperature at 900 °C with ϕ = 0.4 in fuel reactor. The corresponding values of cold gas efficiency (CGE), syngas yield (Ysyn) and syngas purity (Psyn) were 80.76%, 1.318 Nm3/kg and 92.06%, respectively. Besides that, the NiO/dolomite exhibited a good cycle performance under this condition. The CGE and Ysyn decreased slightly to 76.26% and 1.265 Nm3/kg after 10 cycles, respectively. Overall, NiO/dolomite is a promising multifunctional material in the CLR process with BPO for syngas production. More attention should be paid to improve the mechanical strength of NiO/dolomite in the future.

Production of Syngas Via Partial Oxidation and CO2Reforming of Coke Oven Gas over a Ni Catalyst

The ReSER-COG Process for Hydrogen Production on a Ni–CaO/Al2O3 Complex Catalyst

Syngas Production Via Combined Oxy-Co2 Reforming of Methane over Gd2O3-modified Ni/SiO2 Catalysts in a Fluidized-Bed Reactor

Syngas Production from Reforming of Methane with Co2 and O-2 over Ni/Sro-Sio2 Catalysts in A Fluidized Bed Reactor

Combination of CO2 Reforming and Partial Oxidation of Methane over Ni/BaO-SiO2 Catalysts to Produce Low H2/CO Ratio Syngas Using a Fluidized Bed Reactor

Hydrogen production by CO2 reforming of CH4 in coke oven gas over Ni–Co/MgAl2O4 catalysts

Syngas production from CO2 reforming of glycerol by mesoporous Ni/CeO2 catalysts

Highly Active and Stable Ni/ZrO2 Catalyst for Syngas Production by CO2 Reforming of Methane

Methanation of Coke Oven Gas over Ni-Ce/γ-Al2O3 Catalyst Using a Tubular Heat Exchange Reactor: Pilot-scale Test and Process Optimization

Reforming of CH4with CO2and O2to Produce Syngas over CaO Modified Ni/SiO2catalysts in a Fluidized Bed Reactor

Combined Carbon Dioxide Reforming and Partial Oxidation of Methane to Syngas over Ni−La2O3/SiO2 Catalysts in a Fluidized-Bed Reactor

Syngas production from methane dry reforming over Ni/Al2O3 catalyst

High-performance Nano-Structured Ni Based Catalysts for High-Temperature CO2CH4 Reforming—greenhouse Gases to Syngas

Reforming of CH 4 with CO 2 and O 2 to produce syngas over CaO modified Ni/SiO 2 catalysts in a fluidized bed reactor

Tuning Single Atom-Nanoparticle Ratios of Ni-based Catalysts for Synthesis Gas Production from CO2

Carbon dioxide reforming of methane over MgO-promoted Ni/SiO2 catalysts with tunable Ni particle size

Production of Synthetic Natural Gas by CO Methanation over Ni/Al2O3 Catalyst in Fluidized Bed Reactor

Syngas production via chemical looping reforming biomass pyrolysis oil using NiO/dolomite as oxygen carrier, catalyst or sorbent

Combined Carbon Dioxide Reforming and Partial Oxidation of Methane to Syngas over Ni−La<sub>2</sub>O<sub>3</sub>/SiO<sub>2</sub>Catalysts in a Fluidized-Bed Reactor

Partial Oxidation Of Methane To Syngas Over Ni-Based Catalysts

Preparation of Syngas Via Catalytic Gasification of Biomass with a Nickel-based Catalyst