Abstract:Distributed laser measurement systems, widely used in high-end equipment such as airplanes, ships, and other manufacturing fields, face challenges in large spatial measurements due to laser plane obstructions and weak intersections. This paper introduces a novel omnidirectional sensor with enhanced adaptability to complex environments and improved measurement accuracy. Initially, an integrated omnidirectional measurement model is established, followed by the analysis of the optical path of the front-end detector, and the design of a signal-conditioning circuit for the photoelectric conversion of the front-end laser signal, Subsequently, a circuit testing platform is established to validate the detection functionality, and the corresponding results indicate that the symmetry of the output waveform is under 10 ns, the response time is under 100 ns, and the maximum detection distance is 22 m. Further, experimental results demonstrate the superiority of omnidirectional sensors over planar ones in complex environments, successfully receiving 360° laser signals. The positional accuracy of the common point to be measured on the top of the omnidirectional sensor is confirmed to exceed 0.05 mm, and the accuracy of the angle of attitude exceeds 0.04°. Using the laser tracker, the measurement accuracy of the system is verified to be better than 0.3 mm. When rotating in the horizontal and pitch directions, the measurement accuracy is better than 0.35 mm and 0.47 mm, respectively, fulfilling the sub-millimeter precision requirement and expanding the application scope of distributed laser measurement systems.

Non-contact laser aiming detector based on half facular point optical imagery applied in coordinate measurement machine

Research on high-speed and non-contact angle detection based on laser measurement

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

A quadrant detector based laser alignment method with higher sensitivity

A Novel Method to Simultaneously Measure the Straightness

Present Status of High Precision Laser Displacement Sensor Based on Triangulation

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Research on a Novel Laser Displacement Sensor used for Gauge Measurement

Digitalization of Unknown Free-Form Surface Based on Variable-Direction Point Laser Sensor

Distance Measuring Using Single-Point Laser Triangulation System Design Based on CMOS

A New Optical Angle Measurement and Compensation

Full Area Covered 3D Profile Measurement of Special-Shaped Optics Based on a New Prototype Non-Contact Profiler.

2D Micro-Angle Sensor Based on Laser Autocollimation

Noncontact Laser Probe in Industrial Measurement

Calibration of the laser displacement sensor and integration of on-site scanned points

Omnidirectional Sensor Design for Distributed Laser Measurement Systems

Fiducial-aided Calibration of a Displacement Laser Probing System for In-Situ Measurement of Optical Freeform Surfaces on an Ultra-Precision Fly-Cutting Machine.

A Scheme for Enhancing Precision in 3-Dimensional Positioning for Non-Contact Measurement Systems Based on Laser Triangulation

Dynamic scan detection of focal spot on nonplanar surfaces: Theoretical analysis and realization

A Position and Attitude Measurement Method Based on Laser Displacement Sensor and Infrared Vision Camera