Abstract:An experimental setup has been constructed to study the performance of a single-stage double-inlet Gifford-McMahon-type pulse tube refrigerator, where the oscillating amplitudes of the physical quantities are large and oscillating frequencies are low in the system. Temperature distributions on the surface of the regenerator and the pulse tube, as well as the refrigeration capacities at different refrigeration temperatures under optimal operation conditions, were measured. A transient one-dimensional numerical simulator has been developed to verify experimental data and to study the nonlinear dynamic characteristics in the double-inlet pulse tube refrigerator. In this numerical simulator, the state equation and the conservation equations of mass and momentum in the fluid phase, as well as the energy equations for the fluid and the solid, are spatially and temporally conjugated. The boundary conditions and the initial conditions for these governing equations are specified, and finite difference solutions at cycle steady states were obtained. The assumption that the refrigeration temperature at the cold-end heat exchanger is kept at a constant and known value during a cycle in the existing simulations is relaxed in our simulator. Instead, the refrigeration capacity is given, whereas the refrigeration temperature is determined from the numerical solution. Fluctuations of all physical quantities at cycle steady states are discussed. When the cycle-averaged values of the physical quantities are analyzed, it is shown that there is a dc flow through the double-inlet valve at a cycle steady state, and the cycle-averaged velocity in the system is negative due to the mass streaming. At cycle steady states, the cycle-averaged pressure of the compressible flow oscillating at a low frequency is shown to have a positive gradient along the axial location with its largest value in the reservoir. Numerical results are shown to be in good agreement with experimental data.

Complete linear model for double-inlet pulse tube cooler

Linear model analysis of a double-inlet pulse tube cooler

Generation Mechanism of DC Flow in Double-Inlet Pulse Tube Coolers

Experimental Results of the Internal Process of A Double Inlet Pulse Tube Refrigerator

Experimental investigation on DC flow suppression and refrigeration characteristics of a high-performance single-stage GM-type

Phase Shift Mechanism of Pulse Tube Cooler Based on Fluid Network Theory

Experimental Investigation of Regenerator Matrices on Performance of Pulse Tube Cooler

Investigation on High-Performance Single-Stage GM-Type Pulse Tube Cooler

Influence of Input Acoustic Power on Regenerator’s Performance

Thermodynamic Calculation of Three-stage Pulse Tube Refrigerator

Numerical and Experimental Study of a Gifford-McMahon-Type Pulse Tube Refrigerator

Modeling of Heat Transfer and Oscillating Flow in the Regenerator of A Pulse Tube Cryocooler Operating at 50 Hz

A Numerical Model Of A Miniature Multi-Bypass Pulse Tube Cooler

Numerical Simulation of Entire Pulse Tube Refrigerators

Theoretical and Experimental Study for the Transient Behavior of a Linear Compressor During Pulse Tube Cryocooler Cool Down Process

Improvements of Pulse Tube Refrigerator Revisited: Application of Field Synergy Principle

Thermodynamic Performance Prediction Of Pulse Tube Refrigeration With Mixture Fluids

Effects of reservoir volume on performance of pulse tube cooler

An Adiabatic Model For A Two-Stage Double-Orifice Pulse Tube Refrigerator To Reach Liquid Helium Temperatures

A Numerical Model of A 4k Two-Stage Pulse Tube Cooler with Mixed Eulerian-Lagrangian Method

Numerical Simulation and Experimental Verification of the Oscillating Flow in Pulse Tube Refrigerator