Abstract:We have attempted to apply the computer-based finite element analysis (FEA) method to accurately measure the mechanical properties (e.g., hardness and elasticity) of a soft material by an indentation test. First, an axisymmetric model has been developed using commercially available FEA code ANSYS. The FEA model consisted of a thin Al-film resting on Si-substrate. A spherical indenter has been used to indent the Al-film, which traveled a predefined depth during the loading and unloading cycles. First, numerical simulations were conducted to get the force vs. displacement plot, which was later used to determine the modulus of elasticity and hardness of Al-film. The effects of substrate modulus and indentation depth were thoroughly investigated to determine the modulus and hardness of Al-film. The effect of friction, considered at the interface of indenter and Al-film, was found to offer minimum impact for relatively small indentation depth. The induced force on the Al-film by the indenter has been found to be higher with increasing indentation depth when friction was considered. However the contact stiffness, represented by the slope of the unloading curve, has been found almost the same with and without considering friction. The variation of substrate modulus has been found to be ineffective to capture the Al-film modulus for relatively small indentation depth. However for higher indentation depth, the substrate modulus has been found to offer profound effect to capture the film modulus. The hardness of the Al-film has also been found to be relatively unaffected with variation of substrate modulus. However, the hardness of the Al-film has been found to be higher with friction for relatively high indentation depth. Results obtained from this preliminary research are important to continue further investigation and to characterize the mechanical properties of other soft-materials, e.g., biofilms to minimize its detrimental effects and utilize its favorable aspects in industrial and biomedical applications.

Indentation Depth Dependence of the Mechanical Strength of Ni Films

Depth-Sensing Indentation-Based Studies of Surface Mechanical Behavior and Fatigue Damage Evolution of an Austenitic Stainless Steel Subjected to Cyclic Straining

Size effect of nickel-based single crystal superalloy revealed by nanoindentation with low strain rates

The Effect of Indenter Angle on the Microindentation Hardness

Indentation Size Effect in Electrodeposited Nickel with Different Grain Size and Crystal Orientation

Indentation Size Effect: A Study Via The Mechanism-Based Strain-Gradient Plasticity Theory

Indentation Depth-Dependent Hardness of Metal-Organic Framework Crystals: the Effect of Local Amorphization Induced by Indentation

Thickness and Grain Size Dependent Mechanical Properties of Cu Films Studied by Nanoindentation Tests

The role of rough surface in the size-dependent behavior upon nano-indentation

Indentation Depth-Dependence of the Hardness of NiTi Shape Memory Alloy and Al Single Crystal: Phase Transition Versus Plasticity

Impact of Micro-Indentation on Hardness and Indentation Depth of Ni-Cr Super Alloys

Multiscale Analysis of Size Effect of Surface Pit Defect in Nanoindentation

Indentation pop-in as a potential characterization of weakening effect in coating/substrate systems

Size dependent mechanical properties of nanocrystalline Cu films

Spherical indentation on biological films with surface energy

Indentation Stress Relaxation Behavior in As-Deposited and Rolling Nanocrystalline NiFe

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

Indentation Size Effects of Mechanical Behavior and Shear Transformation Zone in Thin Film Metallic Glasses

Multiscale Simulation of Surface Defects Influence Nanoindentation by a Quasi-Continuum Method

Ni/Ni3Al interface-dominated nanoindentation deformation and pop-in events