Abstract:ITO was prepared by mixing gradient In2O3 and SnO2 powders using solid-phase reaction manner. Using electron beam gun tool, ITO films with varied thicknesses were fabricated. The structures and electrical and optical parameters of the prepared films were studied. XRD patterns were used to establish the micro-structural parameters (lattice strain and crystallite size). The SEM shows improvement of grain size with the increase of the film thickness. The electrical parameters of ITO films were measured by means of the standard four-point probe method. It was found that when the film thickness increases from 75 to 375 nm, the resistivity decreases to lower value of 1.65 × 10–4 Ω cm and slightly increases to 1.93 × 10–4 Ω cm at thickness of 375 nm. The ITO films with lower electrical properties are appropriate for high-efficiency CdTe solar cells. In terms of spectral ellipsometry, three optical layer models (adhesive layer of the substrate/B-spline layer of ITO film/surface roughness layer) were applied to estimate the film thickness with high accuracy. The absorption coefficient and energy gap were calculated from the transmission and reflection spectra in the strong absorption region. As the film thickness increases, the optical energy gap was found to increase from 3.56 to 3.69 eV. In terms of Hall effect measurements, both carrier concentration and hall mobility were determined. In addition, influences of ITO layers with various thicknesses on the performance of CdS/CdTe solar cells were checked. When the ITO window layer thickness is 325 nm, Jsc = 17 mA/cm2, Voc = 0.82 V, and FF = 57.4%, the calculated highest power conversion efficiency (PCE) is 8.6%.

Microstructure, electrical and optical properties of Cd-doped CdTe thin films deposited by close-spaced-sublimation

Structure and Optical Properties of Te-doped CdTe Thin Films

Structural and optical properties of Te doped CdS films

Microstructure and optical properties of CdTe thin films prepared by close spaced sublimation method at various growth temperatures

Studies of Structure,Composition and Photoelectric Properties of CdTe Thin Film Grown by Vacuum Sublimation

Microstructue and Optical Properties of Mg-doped ZnO Thin Films Prepared by Sol-gel Method

Characterization of Bi-Catalyzed Nanocrystalline CdTe Thin Films Prepared by Close Spaced Sublimation

Effect of Substrate and Zn Doping on the Structural, Optical and Electrical Properties of Cds Thin Films Prepared by Cbd Method

Texture-tuned Growth of CdTe Thin Films by Closed-Space Sublimation Technique

Tuning of Electrical and Optical Properties of Tantalum Doped TiO2 Flims Prepared by Sol-gel Method

Influence of deposition time in CdTe thin film properties grown by Close-Spaced Sublimation (CSS) for photovoltaic application

Silicon Doping Effect on the Crystallization Behavior of Ge2Sb2Te5 Film

Microstructures and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Chemical Vapor Deposition

Microstructure and Electrical Properties of Al-doped ZnO Thin Films

Structure, Electrical and Optical Properties of ITO Thin Films and Their influence on Performance of CdS/CdTe Thin-Film Solar Cells

Effects of Oxidation and CdCl2 Treatment on the Electronic Properties of CdTe Polycrystalline Films

Synthesis of CdTe thin films on flexible metal foil by electrodeposition

Study of Structural, Electrical and Optical Properties of (200)-Oriented CdTe Thin Films Depending on the Post-deposition Low Temperature

Structural, electrical, and optical properties of ITO thin films and their influence on performance of CdS/CdTe thin-film solar cells

Microstructure evolution, dielectric properties, and nonlinear response of Na+-doped CdCu3Ti4O12 ceramics

Preparation of CdTe Film with Close-Space Sublimation