Abstract:N-type polycrystalline higher manganese silicide ( MnSi 1.7) films are prepared on thermally oxidized silicon substrates by magnetron sputtering. MnSi 1.85, Si , and carbon targets are used in the experiments. By co-sputtering of the MnSi 1.85 and Si targets, n-type MnSi 1.7 films are directly obtained. By increasing the Si content to the deposited films, both the Seebeck coefficient and electrical resistivity increase to high values. A Si intermediate layer between the MnSi 1.7 film and substrate plays an important role on the electrical properties of the films. Without the interlayer, the Seebeck coefficient is not stable and the electrical resistivity is higher. For preparation of MnSi 1.7 films by solid phase reaction, a sandwich structure Si / MnSi x/ Si (x < 1.7) and thermal annealing are used. A carbon cap layer is used as a doping source. With the carbon doping, the electrical resistivity of the MnSi 1.7 film decreases, while the Seebeck coefficient increases slightly. For reactive deposition, the MnSi x (x < 1.7) film is directly deposited on the heated substrate with a Si intermediate layer. By using a Si cap layer, a MnSi 1.7 film with a Seebeck coefficient of -292 μ V/K and electrical resistivity of 23 × 10-3 Ω- cm at room temperature is obtained. The power factor reaches 1636 μW/mK2 at 483 K. With such a high power factor, the n-type MnSi 1.7 material may be superior to p-type MnSi 1.7 material for the development of thermoelectric generators. Several smaller (0.036 - 0.099 eV ) and intermediate (0.10 - 0.28 eV ) activation energies are observed from the curves of logarithm of the resistivity versus reciprocal temperature. The larger activation energies (0.35 - 1.1 eV ) are consistent with the reported energy band gaps for higher manganese silicides.

Preparation of Mn - Si Compound and Its Seebeck Effect

Microstructures and Thermoelectric Properties of Higher Manganese Silicide Prepared by Rapid Solidification and Hot Pressing

PREPARATION OF N-TYPE HIGHER MANGANESE SILICIDE FILMS BY MAGNETRON SPUTTERING

Enhancement Of Thermoelectric Power Factor Of Mnsi1.7 Films By Si Addition And Modulation Doping

Thermoelectric Properties of P‐type Higher Manganese Silicide Films Prepared by Solid Phase Reaction and Reactive Deposition

Effectively Restricting MnSi Precipitates for Simultaneously Enhancing the Seebeck Coefficient and Electrical Conductivity in Higher Manganese Silicide

Research Progress on the Improvement of Thermoelectric Properties of Mg2Si-based Materials

The Effects of Sintering Conditions and Processes on the Thermoelectric and Tribological Properties of High Manganese Silicide Mn4Si7

Influence Of Pre-Annealing And Mn Plus Al Double Doping On The Microstructure And Thermoelectric Properties Of Iron Disilicide

Thermoelectric Properties of Undoped High Purity Higher Manganese Silicides Grown by Chemical Vapor Transport

Preparation of n-type nano-scale MnSi1.7 films by addition of iron

Thermoelectric Properties of Mnsi1.7 Films with Addition of Aluminum and Carbon

Preparation and Thermoelectric Properties of SiC Matrix Composites Prepared under a Low Sintering Temperature

Effect of Sb-Doping on the Thermoelectric Properties of Mg2Si Based Compounds

Microstructure and Thermoelectric Properties of SiGe-added Higher Manganese Silicides

Eco‐Friendly Higher Manganese Silicide Thermoelectric Materials: Progress and Future Challenges

Si-Based Materials for Thermoelectric Applications

Electrical Properties of P-type FeSi_2 Based Thermoelectric Materials Doped with Sm and Mn

Influence of Pre-annealing on the Microstructure and Thermoelectric Properties of Mn + Al Doped Iron Disilicide Prepared by Rapid Solidification and Hotpressing

Latest development of MnSi1.7 semiconducting films