Abstract:The effect of Bi2O3 on ZnO-based varistor ceramic sintered around 800 °C is still not fully understood, because most of the ceramic cannot reach full densification at this low-temperature. Therefore, (balanced) ZnO–0.5 mol% V2O5–0.5 mol% MnCO3–0.5 mol% Co2O3–0.5 mol% TiO2–xmol% Bi2O3 (x = 0, 0.01, 0.05, 0.1 and 0.2) ceramic was designed and prepared by the solid-state sintering at 800 °C. The effect of Bi2O3 variation on the microstructure and electrical nonlinearity of the sample material was studied by using methods of XRD SEM, STEM, EDS and E–J test. Bi2O3 can further activate the reaction at the interface between the V-rich liquid phase and ZnO grains during sintering. This enhanced interface reaction is the key reason to the extremely low-temperature sintering of the ceramic at 800 °C. The variation of Bi2O3 in the 0–0.2 mol% range barely influences the constituents of the ceramic, which consists of ZnO main phase and two other secondary phases: Zn3(VO4)2 and Zn2TiO4. Most of Bi2O3 tends to segregate at grain boundaries. As a result, a soaking time longer than 4 h is needed to allow Bi ions diffusing into enough grain boundaries and improving the nonlinearity of ZnO based varistor ceramic. The sample containing 0.01 mol% Bi2O3 and sintered at 800 °C for 8 h has the best properties of a 43.3 nonlinear coefficient, a 2300 V/mm breakdown voltage and a 0.13 mA/cm2 leakage current density.

A New Method for Studying the Conduction Mechanism of ZnO-based Varistor Ceramics

A new method for investigating the conduction of ZnO-based varistor ceramics

Elaboration and electrical characterization of ZnO-based varistor ceramics in different sintering temperatures

Effect of Minor Bi2O3 Doping on the Microstructure and Electrical Nonlinearity of the ZnVSnO Based Varistor Ceramics

The Conduction Process and the Equivalent Barrier Height in ZnO-Bi2O3 Based Varistor Ceramics

Influence of SnO2 on ZnO–Bi2O3–Co2O3 Based Varistor Ceramics

Study on the electrical properties and defect structures of a high voltage gradient ZnO varistor

The Dependence of Sintering Temperature on Schottky Barrier and Bulk Electron Traps of ZnO Varistors

Effect of Bi2O3 on the ZnVMnCoTiO based varistor ceramic sintered at 800 °C

Structural and electrical properties of ZnO–V2O5–TiO2–Co2O3–MnO varistor ceramics with low sintering temperature

Fabrication of High Performance ZnV Sb System Varistor Ceramics

Research method and mechanism analysis of a novel high-performance quaternary Zn–Sr–Co–Sb varistor ceramic

Microstructure design and optimization of ZnO-Bi 2O 3-Sb 2O 3 based ceramic varistors

Admittance Spectroscopy of Y<sub>2</sub>O<sub>3</sub>-Doped ZnO Varistors Sintered at Different Temperature

Study on the Electrical Properties and the Ac Conductance Response of ZnO-Based Varistor

Influence of Y2O3 on Electrical Properties and Dielectric Characteristics in ZnO Based Varistor Ceramics

SbVO 4 Doped ZnO–V 2 O 5 -Based Varistor Ceramics: Microstructure, Electrical Properties and Conductive Mechanism

Dual Effects of V2O5 in ZnO-V2O5 Varistor Ceramics During Low Temperature Sintering

Microstructure Design and Optimization of ZnO-Bi2O3-Sb2O3 Based Ceramic Varistors

Cold Sintering Process for Fabrication of High Voltage Gradient ZnO Varistors

Microstructure and Electrical Properties of ZrO2-doped ZnO Varistor Ceramics