Abstract:A series of vaned-diffusers, which are with various vane inlet angles, vane angle distributions along streamline, leading and trailing edge positions, were designed for a mixed-flow pump impeller by using the point-by-point integration method that was applied to generate the three-dimensional camber of vane on the streamlines determined by employing an iterative calculation between two kinds of relative stream surfaces. The vane thickening and leading and trailing edges smoothing were conducted on a plane of conformal mapping. 3D turbulent flow fields inside the mixed-flow pump with the same impeller but different diffusers were simulated by solving the Reynolds time-averaged N-S equations and the standard k-ε turbulence equations based on SIMPLE algorithm, and the pump hydraulic efficiencies were predicted, consequently, the correlations of both the vane wrap angle and hydraulic efficiency to different design parameters were obtained. In addition, effects of various design parameters on the mixed-flow pump performance were analyzed by means of relative velocity, static pressure and total pressure distributions in the inlet and outlet to the diffusers. The results showed that the diffuser vane inlet angle has the strongest influence on the performance and a reasonably selected inlet angle can reduce the shock loss. The vane angle distributions along streamlines should be selected by considering the control of wrap angle to reduce the hydraulic friction loss in diffuser. The leading edge and trailing edge positions should be selected with the consideration of static pressure recovery ability and hydraulic friction loss across diffuser.

Optimized Design on Micro -Diffuser/nozzle Facing Micro Pump

Loss Coefficient and Rectification Efficiency Based on Valveless Micropump

Coupled Electrostatic-Structures-Fluidic Analysis of a Nozzle/Diffuser Diaphragm Micropump

Analysis of the Flow Characteristics of Diffuser/Nozzle Based on MEMS

Research and Fabrication of a Low-Cost Valveless Micropump Based on Piezoelectric Actuation

A Micro Diffuser/Nozzle Pump with Fins on the Sidewall

Development of micro pump with micro fins.

Multi-Point Optimization on the Diffuser of an Axial Flow Pump

Effects of Structural Parameters and Rigidity of Driving Diaphragm on Flow Characteristics of Micro Valveless Pump.

Characteristics Of Gas Flow Within A Micro Diffuser/Nozzle Pump

FABRICATION AND GAS FLOW CHARACTERISTICS ANALYSIS OF MICRO DIFFUSER/NOZZLES

The Optimization of A Low Specific Speed Pipeline Pump

Performance Optimization of Nozzle-Diffuser Piezoelectric Micropump with Multiple Vibrating Membranes by Design of Experiment (DOE) Method

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Design of Microfluidic Channel Networks with Specified Output Flow Rates Using the CFD-based Optimization Method

Design, fabrication and micro-PIV measurement on no-moving-part micro-pump

Optimization of Bellows in Bellows Pumps for Higher Pumping Efficiency

Micro-Jet Pump for Micro-Fluidic Systems

Study on the Diffuser/Nozzle-Based Valve Less Piezoelectric Pump

Effects of diffuser vane on mixed-flow pumps performance

Effect of Space Diffuser on Flow Characteristics of a Centrifugal Pump by Computational Fluid Dynamic Analysis