Abstract:Adding lanes is a common method to increase the capacity at intersections. The additional turning lanes are often limited by the road configuration. The paper presents a probabilistic model to calculate the total capacity at signalized intersections for a full through lane and an additional left-turn lane. The proposed model has an advantage over current estimation methodologies by considering not only stochastic arrivals of vehicles but also the signal timing plan, especially signal phasing sequence. Two blockage situations under this channelization form arc taken into account. The proposed capacity model shows that the capacities of the through and left-turn movements are related to the proportion of the through traffic volume, the length of the additional turning lane, and the effective green time of both through and left-turn signal phases. It is also found that the through capacity increases with the increase of the proportion of the through traffic and the length of the additional lane, whereas the left-turn capacity declines with an increase of the proportion of the through traffic but increases with an increase of the length of the additional lane. Both capacities decrease with the increase of the green time when the g/C ratio is fixed. The proposed model is compared with design recommendations and verified using the microscopic traffic software VISSIM as well as field data. The results show that the capacities obtained by theoretical models are consistent with the simulated results, and have an advantage over the design recommendations. The capacity models can provide theoretical suggestions for the design of additional turning lanes and signal timing plans. (C) 2018 American Society of Civil Engineers.

Capacities and Delays of Non-Motorized Traffic Streams at Signal-Less Intersections

The influence of non-motorized streams on capacities of vehicular streams at unsignalized intersections

Influence of signal on the capacity of signalized intersection

Bicycle and Pedestrians' Arrival and Departure Characteristics at Signalized Intersection

Capacity of unsignalized intersection with mixed distribution headway

Method of computing left-turn vehicle traffic capacity at two-phase intersection

Calculation method of travel time of right-turn vehicle at motor-and nonmotor-vehicle mixed traffic intersection

Bicycle Conversion Factor Calibration at Two-Phase Intersections in Mixed Traffic Flows

Implementing Actuated Signal-Controlled Intersection Capacity Analysis with Pedestrians

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Modeling Capacity of Shared Right-Turn Lanes at Signalized Intersections Considering the Lag Green Time of Right-Turns

Determination Method of Critical Traffic Volume for Signal Setting at T-Intersections

Maximum cycle length optimization method of signalized intersection

Conflict delay models at two-phase intersection

Traffic flow model by simulating circuit at signalized intersections

Signal Timing Method of Right——turn Vehicles Based on Mixed Traffic

A Group-Based Signal Timing Optimization Model Considering Safety for Signalized Intersections with Mixed Traffic Flows

Study on Pedestrian Signal Cycle Optimization

A study on the capacity of exclusive right-turn lanes of at-grade intersections

Analytical Model of Passing Events for One-Way Heterogeneous Bicycle Traffic Flows

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections