Abstract:Adding lanes is a common method to increase the capacity at intersections. The additional turning lanes are often limited by the road configuration. The paper presents a probabilistic model to calculate the total capacity at signalized intersections for a full through lane and an additional left-turn lane. The proposed model has an advantage over current estimation methodologies by considering not only stochastic arrivals of vehicles but also the signal timing plan, especially signal phasing sequence. Two blockage situations under this channelization form arc taken into account. The proposed capacity model shows that the capacities of the through and left-turn movements are related to the proportion of the through traffic volume, the length of the additional turning lane, and the effective green time of both through and left-turn signal phases. It is also found that the through capacity increases with the increase of the proportion of the through traffic and the length of the additional lane, whereas the left-turn capacity declines with an increase of the proportion of the through traffic but increases with an increase of the length of the additional lane. Both capacities decrease with the increase of the green time when the g/C ratio is fixed. The proposed model is compared with design recommendations and verified using the microscopic traffic software VISSIM as well as field data. The results show that the capacities obtained by theoretical models are consistent with the simulated results, and have an advantage over the design recommendations. The capacity models can provide theoretical suggestions for the design of additional turning lanes and signal timing plans. (C) 2018 American Society of Civil Engineers.

Method of computing left-turn vehicle traffic capacity at two-phase intersection

Passing Capacity of Advance Right-Turn Motor Vehicles

Based on Simulation Method for Solving Traffic Jam Problems.

Calculation method of travel time of right-turn vehicle at motor-and nonmotor-vehicle mixed traffic intersection

Planning methods and effect analysis of advance right-turn

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Conflict delay models at two-phase intersection

Modeling Capacity of Shared Right-Turn Lanes at Signalized Intersections Considering the Lag Green Time of Right-Turns

Capacity of unsignalized intersection with mixed distribution headway

Modeling capacity of shared right-turn lanes considering right turn on red and lag green time of right-turn

Analysis om waiting area for left-turn vehicles at signalized intersections

Bicycle Conversion Factor Calibration at Two-Phase Intersections in Mixed Traffic Flows

Determination Method of Critical Traffic Volume for Signal Setting at T-Intersections

Signal Timing Method of Right——turn Vehicles Based on Mixed Traffic

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections

Influence of signal on the capacity of signalized intersection

A study on the capacity of exclusive right-turn lanes of at-grade intersections

Critical traffic volume of traffic signal warrant under limited priority condition

Left-Turn Lane Capacity Estimation based on the Vehicle Yielding Maneuver Model to Pedestrians at Signalized Intersections

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Delay Estimation and Application Conditions of Two-Legged Continuous Flow Intersection