Abstract:This work aims to improve the combined flow and thermal network (CFTN) accuracy for radially air-cooled generators by investigating the possible error stemming from the flow part. The nonlinear resistance characteristics of the T-junction dividing flow are first time considered for such cooling arrangement, which is achieved by employing the Gardel equations and the blend equation as the governing equations. Compared with the CFD model results as the benchmark, the nonlinear CFTN predicts an accurate flow rate in the radially extended airducts, making only 9% root mean square (rms) error for all the airducts. On the contrary, the linear CFTN fails to obtain a reliable flow distribution, as the rms error is as large as 34%. As a result, the nonlinear CFTN improves the accuracy of the maximum winding temperature by 6.4% over the linear CFTN and gives a more reasonable temperature gradient in the axial direction. Furthermore, the relative difference between the linear and nonlinear CFTNs is found to be even larger in the following conditions: large cooling air flow rate, wide airgap, low slot fill factor, and large airduct number. The proposed nonlinear CFTN modeling approach is also validated against experimental measurements for a prototype. The modeled temperatures match well with the measurements at different axial positions. According to the aforementioned findings, the nonlinear CFTN modeling approach is considered to be a reliable thermal analysis tool for the radial air-cooling arrangement.

Research on the Nonlinear Thermal-liquid Coupled Network Model of Whole Stator of Three-gorge Generator

Water Cooling System Design and Thermal Analysis for Electrical Vehicle Driving Motors

Ventilation and Stator Temperature Field of Bulb Tubular Turbine Generator

Optimal Analysis on Temperature Field of Stator Ventilation System Based on Longitudinal Vortex Generator

Calculation on 3D Static Thermal-flied of Three-gorge Half-cooled Hydrogenerator Stator by Using Thermal-liquid Coupling Element

Comparing Between 3D Finite-element Method and Thermal-circuit Method of Calculating Thermal-resistances in the Thermal Field of Three-gorge Hydrognerator

Thermal Analysis of a Permanent Magnet Generator with Built-in Hydrostatic Drive

Full 3D eddy current and temperature field analysis of large hydro-generators in different operating conditions

Numerical calculation of 3D nonlinear steady-state temperature field for a large synchronous generator

3D Eddy Current and Temperature Field Analysis of Large Hydro-Generators in Leading Phase Operations

Improving Combined Flow and Thermal Network Accuracy for Radially Air-Cooled Generators by Considering the Nonlinear Resistance Characteristics of T-Junction Flow

3D Lumped Parameter Thermal Network for Wound-Field Synchronous Generators

3D nonlinear steady-state temperature field after stator winding insulation laminating for large hydro-generator

HEATING ANALYSIS OF STATOR STRANDS OF LARGE HYDRO-GENERATOR BASED ON NUMERICAL METHOD

Temperature and Fluid Flow Field Calculation and Analysis of Stator End of Air Cooled Turbo-generator

Numerical Calculations of the Coupled Eddy Current-Temperature Fields in the End Regions of Large Hydro-Generator Using MagNet and ThermNet Software

Calculation of Nonlinear Stator Temperature Field after Insulation Aging for Large Generator

Analysis and Calculation of Nonlinear Flow Field and Stator Temperature Field in Stator Radial Ventilating Grooves for Large Hydro-Generator in the Case of Insulation Aging

Thermal Field Calculation Coupled with Fluid Field for Permanent Magnet Direct-Driven Wind Power Generator with Evaporative Cooling System and Air Cooling System

Study on the Fluid-Solid Coupling Heat Transfer in the Stator of Large Synchronous Condenser Considering Complex Transposition Structure

Calculation and Analysis of the Surface Heat-Transfer Coefficient and Temperature Fields on the Three-Dimensional Complex End Windings of a Large Turbogenerator