Abstract:It can provide theoretical support for the optimal design of low-energy walls by measuring the actual thermal conditions inside the walls of passive low-energy buildings and studying the rationality of the wall structure design. Taking the teaching and laboratory building of Shandong Jianzhu University as an example, this paper explores the method of using temperature and humidity sensor to measure the air temperature and humidity inside the wall to represent the solid temperature and humidity of the wall. Based on the measured data and calculation results, the rationality of the structure of the test external wall is analyzed from four aspects: the performance of insulation, the moisture drain performance of wall, the ability of preventing the penetration of the hot and humid air of the inner wall, and the waterproof performance of the outer wall. Results show that the external wall structure of polystyrene board (200 mm thick) for external insulation and thin plastering has good practical operation effect in three aspects of thermal insulation, internal moisture discharge, and external wall waterproof, which basically meets the design requirements of external wall of passive house in Germany. In terms of moisture protection of the inner wall, the inner wall of cement mortar (15 mm thick) may not be able to effectively prevent the infiltration of indoor hot and humid air. Thus, the insulation layer should be added into the external wall. In addition, the moisture inside the wall is obviously affected by the season. The drain performance of moisture inside the wall mainly occurs in the sweltering heat, and the drain direction is from the indoor side to the outdoor side. In the external insulation structure, there are two layers of graphite polystyrene plate (100 mm thick), and the insulation effect of polystyrene plate near the outdoor side is better than that near the indoor side. The combination of anticrack mortar (5 mm thick) and paint cannot completely prevent the infiltration of rainwater, but the infiltration of rainwater in the wall will be quickly discharged in a short time.

Study on heat and mass transfer of the slotted light steel-framed composite wall at minimum temperature in Harbin

Numerical Study On Energy Consumption Characteristics For Wall Insulation Structure In Hot Summer And Cold Winter Zone

Numerical Study on Wall Insulation Construction Affecting the Energy Consumption under the Intermittent and Loculose Energy Use

Heat and Moisture Transfer in Wall-to-floor Thermal Bridges and Its Influence on Thermal Performance

Optimum Insulation Thickness of External Walls by Integrating Indoor Moisture Buffering Effect: a Case Study in the Hot-Summer-cold-winter Zone of China

The Energy Saving Effect of Different Wall Insulation Configurations with the Intermittent and Compartmental Heating Method

Finite Element Analysis of 3D Heat Transfer of Typical Thermal Bridge of Self-Thermal Insulation in Hot-Summer and Cold-Winter Zone

The Moisture Distribution in Wall-to-floor Thermal Bridges and Its Influence on Mould Growth

Comparative Studies on the Temperature Stresses in External Walls with Different Thermal Insulation Models

Moisture Distribution in Wall-to-floor Thermal Bridges under the Analysis of Coupled Heat and Moisture Transfer

Finite Element Analysis of Heat Transfer Behavior in Glass Fiber/metal Composite Materials under Constant Heat Load

Effect of thermal parameters on heat storage and release performance of phase change material composite wall

Thermal behavior of external-insulated cold-formed steel non-load-bearing walls exposed to different fire conditions

Field Test and Simulation Analysis of Thermal Performance of Bamboo Steel Composite Wall in Different Climate Regions

Study on Thermal Performance Measurement and Construction of Passive Exterior Wall with Low Energy: Teaching and Laboratory Building of Shandong Jianzhu University

Research of humid air condensation heat transfer across the vertical wall

The Study of Thermal Boundary Condition for CFRP Pressure Vessel with Metallic Liner During Manufacture Process

Numerical Analysis on Thermal Behavior of Composite Wall Combined Autoclaved Aerated Concrete With Thermal Insulting Material in Summer Day

Investigation On Temperature Distribution Of Light Gauge Steel Frame (Lsf) Wall

Thermal performance study of straw concrete external walls for rural residences in hot-summer and cold-winter zone of China

Analysis on mechanical performance of cold-formed steel stud composite walls with holes