Abstract:The 1500V DC feeder cable is one of the key devices for the safety operation of subway system, and its insulation status directly affects the security of electricity supply of rail traffic. Result of study shows that using on-line detecting discharge method to assess its insulating status is feasible, but interference suppression is one key parts of partial discharge detection. Therefore, this paper discusses and studies the potential interference signal in detecting discharge for the direct current cable. The electric wiring of the subway direct current cable is very special, which determine that there are many interference signals in discharge detection signal for the subway direct current cable. The results of laboratory simulation and field measurement shows that the main interferences involves discharge pulse generated by other equipments of the traction substation, white noise, rectifying pulse generated by the rectifying equipments, current pulse generated by the braking of the locomotive,stochastic pulse signal, and narrow-band signal generated by electric equipment. The characteristic of last four kinds of aforementioned signals is mainly investigated in the text. The research results showed that rectifying pulse had good periodicity and synchronously appeared in all parallel cables; narrow-band interference signal and current pulse generated by the braking of the locomotive has big amplitude, but theirs spectrum does not exceed 2MHz; stochastic pulse signal is uncertain, however, its repetition is more lower than the repetition of the discharge signal of the DC feeder cable. Because the discharge recurrence rate is high and the frequency spectrum of discharge is wide, therefore, the FFT, wavelet, time-windows and statistics methods should be synthetically used to suppress interference. Finally, the anti-interference steps are proposed and the effect is given. The work provides a reference for anti-interference for on-line discharge detection for 1500V subway DC cable.

Faults Analysis of DC Feeder Cable and Countermeasures

Analysis of DC Cable Fault in Shanghai Metro

Investigation of On-line Monitoring Method on 1500 V Direct Current Cable of Subway

Review and Expectation of Diagnosis Technology on Insulation of DC Cable of Urban Transit

Development of Online Monitoring System for 1500 V Ethylene–propylene–rubber DC Feeder Cable of Shanghai Urban Rail Transit

Online Monitoring System of DC Feeder Cable for Urban Rail Transit

Analysis and Countermeasure of 110KV Cable Joint Defects

Fault Section Identification of the Power Cables in Urban Distribution Networks by Amplitude Differences Between the Zero-sequence Currents and Those Flowing in Cable Sheaths and Armors

Analysis of Short-circuit Fault in DC Traction Power Supply System for Urban Mass Transit

Research of Interference in On-line Discharge Detection in 1500 V Subway Direct Current Cable

Survey of Power Cable Fault Detection Methods

Typical case analysis of distribution cable fire fault

Dielectric loss and partial discharge test analysis of 10 kV XLPE cable

A Method of Dynamic Risk Analysis and Assessment for Metro Power Supply System Based on Fuzzy Reasoning.

Analysis of the Sheath Voltage in High-speed Railway Feeder Cable Grounding in Single-Ended Mode

Electromagnetic Interference in Control Cables of Substation Caused by Short Circuit Fault

Detection of Insulating Performance for Unarmored Cable under DC Leakage Current

Research on the control and protect system in DC power distribution system

Study on the Test Circuit of Subway DC Traction Power Supply System

Fault Location Method for Three-Core Cable Using Amplitude Ratio of Shield-Grounding Wire Currents

Evaluation Analysis of XLPE Cable's Electrical Condition