Abstract:With the rapid development of urban power system, the proportion of high voltage (HV) power cable transmission lines used in urban power grid was increasing. Under the lightning striking, switching or fault conditions, a high induced voltage could generate on the insulated sheath of cable so it was necessary to protect and limit the sheath induced voltage of HV cable. The sheath voltage limiter (SVL) could be installed between the metal shield of cable and grounding. In order to clarify the temporary and transient characteristics of sheath induced voltage and its influences with the SVL, the models of simulating calculations were established based on a typical 220kV cable transmission line and with the PSCAD/EMTDC software in this paper. The transient characteristic of sheath induced voltage and its influence with the SVL were calculated under the conditions of different short-circuit currents and lightning strike currents, respectively, through the cable core. Two kinds of SVLs with two grounding manners, i.e. cross-bonding grounding and single-point grounding, were investigated respectively. According to the energy absorption capacity of each SVL, the suitability curves of SVL for different cable lengths and short-circuit currents were obtained, which would provide the basis and the improvement approaches for the engineering design of cable grounding. Furthermore, based on the different suitability curves of SVLs, the design principles and typical parameters of the improved SVLs were presented. The improvement effect of a newly improved SVL was analyzed also. The methods used in this research could also be extended to other voltage class cable transmission lines and/or other laying methods.

Analysis of the Sheath Voltage in High-speed Railway Feeder Cable Grounding in Single-Ended Mode

Investigation on Circulation Current Calculation and Grounding Methods of Multi-circuit Cables

lnfluence of high-speed railway cable grounding mode on the induced voltage of the cable sheath

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Performance of Different Grounding Systems of 500 Kv XLPE Long Submarine Cables Based on Improved Multiconductor Analysis Method

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

An Investigation on Grounding System of AC Single-core Submarine Cable Based on Multi-conductor Analysis Theory

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Analysis of Thermo-electric Coupled Simulation for 10 Kv AC XLPE Cable under Different DC Topologies and Laying Modes

Simulation Analysis of Grounding Characteristics of Cable Based on ATP-EMTP

Study on Sheath Voltage and Earth Potential Rises of the Hybrid Overhead-cable Lines

Simulation Analysis of Temperature Field and Electric Field for 10 kV AC XLPE Cable in DC Operation

The Suitability Analyses of Sheath Voltage Limiters for HV Power Cable Transmission Lines

Research on CFETR 110 kV Cable Grounding Scheme

Transient Characteristic Analysis and Parameter Optimization of Sheath Voltage Protector for Large-length High Voltage Cable

Numerical analysis of thermo-electric field for 10 kV AC XLPE cable in DC operation

Fault current calculation and grounding scattering optimization of 220 kV tunnel cable systems

Simulation and analysis of induced voltage and induced current on overhead ground wire of Jindongnan-Nanyang-Jingmen 1000kV UHV AC transmission line

Simulation Analysis of Electromagnetic and Heat Field Distribution in 330kv High Voltage AC Cable

110Kv High Voltage Cable Sheath Transposition to Reduce the Grounding Induction Currents