Abstract:The grounding grid on the outside of the epoxy insulator breaks under the long-term oxidative corrosion of moisture, fails prematurely, and may eventually develop into a breakdown failure. However, the impact of this process has not yet been discovered.In this paper, a 110 kV combined prefabricated cable joint breakdown fault is discussed. Through the inspection and comparative analysis of the faulty joint, it is speculated that the premature failure of the grounding grid causes the breakdown of the epoxy insulator. The fault process can be divided into the grounding failure stage and the insulation damage stage. In this paper, the corresponding two-dimensional electric field simulation calculation model is established, the fault development process is restored, and the possible effects of different stages is analyzed.The results show that due to the corrosive effect of moisture, when the grounding grid is broken, a floating potential will be generated on the surface of the epoxy insulator. With the expansion of the grounding failure range, the local field strength on the surface of the epoxy insulator is distorted, which will cause partial discharge. When the failure range is 220 mm, the electric field distortion of the joint reaches the maximum value of 23.3MV/m, which will destroy the insulation strength of the epoxy insulator and cause insulation breakdown, eventually leading to an accident.The research results point out the importance of the continuity of the grounding grid, and the improvement measure is proposed to reduce the occurrence of such accidents. The analysis method for cable joint failure case can provide a reference for dealing with similar accidents.

Analysis and Countermeasure of 110KV Cable Joint Defects

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Transient Performance of Loss Reduction Strategy for Power Cables Installed on the Bridge

Typical Defect Simulation of 110kv Cable and Its Partial Discharge Characteristic Test

Study on a 110 kV combined prefabricated joint fault caused by premature failure of grounding grid

An Investigation on Grounding System of AC Single-core Submarine Cable Based on Multi-conductor Analysis Theory

Typical case analysis of distribution cable fire fault

Simulation and Partial Discharge Detection for Typical Defects of 10 Kv Cable the Joint

Research on live detection technology of cable joint defects based on high-speed light sensing and pressure wave method

220Kv Transmission Line Fault Diagnosis and Analysis

Fault Location Method for Three-Core Cable Using Amplitude Ratio of Shield-Grounding Wire Currents

Research on Defects of High Voltage Cable Fusion Joint Using XLPE Insulation Material

Fault current calculation and grounding scattering optimization of 220 kV tunnel cable systems

The Coupling Fields Characteristics of Cable Joints and Application in the Evaluation of Crimping Process Defects

Dielectric loss and partial discharge test analysis of 10 kV XLPE cable

Electromagnetic Interference in Control Cables of Substation Caused by Short Circuit Fault

Research on multi-physical field analysis and assessment technique of virtual connection defects in cluster cable joints based on digital twin technology

Fault Analysis and Modified Measures of 500 Kv Compact Transmission Line