Abstract:Using hydroxypropyl terminated polydimethylsiloxane ( HP. PDMS ), isophorone diisocyanate and 2,2-bis( hydroxymethyl ) butyric acid as starting materials, silicone-polyurethane copolymer ( Si-PU ) latexes with particle diameter of about 50 nm were prepared via step-by-step feeding process followed by phase inversion technique in the absence of surfactant. Influences of the HP-PDMS content on the phase structure and the properties of the Si-PU latex films were investigated, and the difference between Si-PU and polyether polyurethane ( E-PU ) was emphasized. It was found that the content of PDMS in Si-PU could reach up to 65 wt%. Results of DSC analysis showed that, in comparison with the E-PU latex film, the Si-PU latex films exhibited well phase separation. Strong hydrogen bonding in Si-PU hard segments was confirmed by FTIR, which promoted the micro. phase separation in the latex films. On the contrary, strong hydrogen bonding existed in between the soft and hard segments in E-PU, which led to phase mixing and prevented the formation of phase separation structure. The Si-PU latex films were characterized by AFM tapping mode and the formation of sea. island phase separation was observed, and this kind of phase separation structure in the Si-PU latex films was rarely reported in the literature, in which the amorphous PDMS. enriched domains constituted the dispersed phases. With the increase in HP. PDMS content, the degree of phase separation in the Si-PU latex films increased as well, which led to the decrease of elastic modulus from 400.0 MPa to 32.2 MPa with an increase in elongation at break and in the flexibility. The initial decomposition temperature of the Si-PU latex films was at about 244 degrees C, which was 18 degrees C lower than that of the E-PU latex film due to the low degree of hydrogen bonding between the soft and the hard segments, whereas the thermal stability of Si-PU at high temperature zone was much better than E-PU. Compare to the E-PU latex film, a low water adsorption rate under 11% and a high contact angle above 94 degrees indicated excellent water resistance of the Si-PU latex films.

Sturcture and Properties of New Aqueous Dispersion Polysiloxane-Polyuretane Copolymers

Synthesis of CO2-Derived, Siloxane-Functionalized Poly(ether Carbonate)s and Waterborne Polyurethanes

Synthesis, Film Morphology, and Performance on Cotton Substrates of Dodecyl/piperazine Functional Polysiloxane

Synthesis, characterization and lubricating effect of long chain branched polydimethylsiloxane-g-polyethylene copolymers

Synthesis of High-Toughness Waterborne Polyurethane Utilizing Self-Emulsifying CO2-based Polyols

The synthesis and properties of siloxane-urethane copolymers aqueous nanodispersion using hydroxyalkyl and hydrohxypolyester terminated polydimethylsiloxane

Synthesis and Properties of Aqueous Polysiloxane-Polyurethane Block Copolymer

Synthesis and Characterization of Waterborne Polysiloxane-Polyacrylates Dispersion

The Core-Shell Structured Aqueous Dispersions of the Siloxane-Grafted Polyurethane Copolymers with High Transparency

Investigation on the Preparation of Silicone-polyurethane Latex, Phase Structure and Property of the Latex Films

Preparation and properties of polysiloxane modified fluorine-containing waterborne polyurethane emulsion

Influence of Siloxane Co-Segment Length and Content of Waterborne Polysiloxane-Urethane Copolymers on Their Water Resistance, Thermal Stability and Mechanical Properties

Synthesis and characterization of polyurethane–polysiloxane block copolymers modified by α,ω-hydroxyalkyl polysiloxanes with methacrylate side chain

Study on the Water Repellent Silicone-Polyurethane Block Copolymers

The Hydrogen Bonding in the Hard Domains of the Siloxane Polyurea Copolymer Elastomers

Surface properties of PDMS segmented/branched modified polyurethane copolymer

Polysiloxanes with Quaternary Ammonium and Polyether Groups for Silyl-Terminated Polypropylene Oxide Waterborne Emulsions

Synthesis and properties of polyurethane modified with an aminoethylaminopropyl-substituted polydimethylsiloxane. II. Waterborne polyurethanes

Synthesis of waterborne polyurethane by inserting polydimethylsiloxane and constructing dual crosslinking for obtaining the superior performance of waterborne coatings

Improving water resistance of waterborne polyurethane coating with high transparency and good mechanical properties

Preparation and Surface Properties of Silicone-Modified Polyester-Based Polyurethane Coats