Abstract:The effect of Ag addition on the precipitation evolution and interfacial segregation for Al–Mg–Si alloys was systematically investigated by atomic resolution high-angle annular dark-field scanning transmission electron microscopy (HAADF-STEM), atom probe tomography (APT) and density functional theory (DFT) calculation. At the early aging stage, Ag atoms could enter clusters and refine the distribution of these clusters. Then, Ag atoms preferentially segregate at the GP zone/α-Al and β"/α-Al interfaces at the peak aging stage by the replacement of Al atoms in FCC matrix. With prolonging aging time, Ag atoms generally incorporate into the interior of β" precipitate, facilitating the formation of QP lattice (a hexagonal network of Si atomic columns) and the local symmetry substructures, Ag sub-unit (1) and Ag sub-unit (2). At the over-aged stage, the Ag sub-unit (1) and Ag sub-unit (2) could transform to the β′Ag (i.e. β′Ag1 and β′Ag2.) and Q′Ag unit cells, respectively. All the precipitates at the over-aging stage have a composite and disordered structure due to the coexistence of different unit cells (β′Ag1, β′Ag2, Q′Ag and β′) and the non-periodic arrangement of Ag atoms within the precipitate. In the equilibrium stage, the incorporated Ag atoms in the precipitates release into the α-Al matrix as solute atoms or form Ag particles. In general, Ag atoms undergo a process of “segregate at the precipitate/matrix interface → incorporate into the interior of precipitate → release into the α-Al matrix” during the precipitation for Al–Mg–Si–Ag alloys. Besides, Ag segregation is found at the interfaces of almost all metastable phases (including GP zone, β″, β′/β′Ag phase) in Al–Mg–Si–Ag alloys. The Ag segregation at the β′/α-Al interface could increase the length/diameter ratio of β′ phase and thus promote the additional strengthening potential of these alloys. These findings provide a new route for precipitation hardening by promoting the nucleation and morphology evolution of precipitates.

Effect of Silicon Addition on the Microstructure and Precipitation of Cast Al-5.3Cu-0.8Mg-0.6Ag Alloys

Microstructure and Precipitation Hardening of As-cast Al-Cu-Mg-Mn-Ag-(-Si) Alloys

Effects of Si Additions on the Precipitation Hardening Response in Al-Cu-Mg(-Ag) Alloys

Effect of Cu addition on precipitation and age-hardening response of an Al-15%Mg2Si alloy

Effect of Trace Silicon Addition on Microstructure and Properties of a Cu–0.26Cr–0.14Mg Alloy

Effects of Ag Addition on Ageing Precipitation and Microstructure Thermal Stability of an Al-Cu-Mg-Mn Alloy

Effect of Si addition on the precipitation and mechanical/electrical properties of dilute Al-Zr-Sc alloys

Microstructure Evolution and Its Effect on Mechanical Properties of Cast Ti48Al6NbxSi Alloys

The Effect of Si Content on the Microstructure and Mechanical Properties of Al–1.2Mg–xSi–1.2Cu–0.6Mn Cast Alloy

Research on Precipitation and Mechanical Properties of Al-Cu-0.4Mg-0.6Ag Alloy

Effects of Ag Addition on the Microstructure and Thermal Stability of 6156 Alloy

The Role of Si on Microstructure, Mechanical and Local Corrosion Behaviors of an Al–Cu–Mg–Si Alloy with High Cu/Mg Ratio

Effects of Cr Addition on the Microstructure and Mechanical Properties of an Al-Si-Cu-Mg Alloy

Effect of Ag Addition on the Precipitation Evolution and Interfacial Segregation for Al–Mg–Si Alloy

Effect of Cu Content on Precipitation and Age-Hardening Behavior in Al-Mg-Si-xCu Alloys

Influence of Mg and Cu on Precipitation Behaviors and Mechanical Properties of Al-Si Alloys

Effects of Si and Ag Additions on Ageing Behaviour and Microstructure Evolution of Al-Cu-Mg Alloy

Microstructures and Mechanical Properties of Al-Cu-Mg-(Ag, La) Alloys

Effect of minor Ag addition on microstructures and properties of Al-Mg-Cu-Li alloy with low Cu/Mg ratio

Effect of Si Addition and Applied Pressure on Microstructure and Tensile Properties of As-Cast Al-5.0Cu-0.6Mn-1.2Fe Alloys

Precipitates evolution and strengthening of Al–Mg2Si alloys containing high-Cu contents during ageing process