Abstract:This paper presents a detailed study on the transient response and stability of the automatic gain control (AGC) with a proportion-integral (PI) controller for a MEMS vibratory gyroscope, which constructs a closed-loop control system to make the gyroscope achieve a constant amplitude vibration at its resonant frequency. The nonlinear mathematical model for the control system is established by applying the averaging and linearization method, which is evaluated through numerical simulations. The stability and convergence characteristics of the whole loop are investigated by using the phase plane method and Routh-Hurwitz criterion. The analysis provides a quantitative methodology for selecting the system parameters to approach stability and an optimal transient response. The negative impact induced by drift of the resonant frequency and Q-factor is also discussed. Simulation results predicted by the model are shown to be in close agreement with the experimental results carried out on a doubly decoupled bulk micromachined gyroscope. By optimizing the control parameters, the measured rising time is less than 100 ms without obvious overshoot. The setting time of the whole loop is less than 200 ms with the relative fluctuation of velocity amplitude within approximately 16 ppm for an hour. The resulting overall performance of the gyroscope is tested under atmospheric pressure. The resonant frequencies and the Q-factor of the drive mode and sense mode are 2.986 kHz, 213 and 3.199 kHz, 233, respectively. The gyroscope achieves a scale factor of 27.6 mV/deg/s with nonlinearity less than 120 ppm in the full-scale range of 800 degrees s(-1). The threshold of sensitivity is measured to be about 0.005 degrees s(-1) with noise equivalent angular rate evaluated to be 0.001 degrees/s/Hz(1/2).

The Design of Automatic Gain Control in Self-Excitation Drive Circuit of Gyroscope

Analysis on Digital Automatic Gain Control of MEMS Gyro Driven-Loop Circuit

Drive Mode Control for MEMS Gyroscopes with Electrostatically Tunable Structure

Design and Test of MEMS Gyroscope Control System Based on LMSD

A Novel Amplitude-Phase Information Extraction Architecture for MEMS Vibratory Gyroscopes Using a Modified Double Side-Band Demodulation Configuration

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

High Performance Interface Circuit for MEMS Gyroscope

A Novel Closed-loop Drive Circuit for the Micromechined Gyroscope

Analysis and Design of Drive Closed-Loop for Mems Vibratory Gyroscope

A Closed-Loop Self-Excited Drive Circuit for Quartz Gyroscope

Digital closed-loop controller design of a micromachined gyroscope based on auto frequency swept

Study on electrostatic self-excited driving for tuning fork micromachined gyroscope with large Q value

Digital Closed-Loop Control Based on Adaptive Filter for Drive Mode of a MEMS Gyroscope

The design and implementation of interface electronics for silicon micromechanical gyroscopes

CMOS Variable Gain Amplifier for Gyroscope Closed-Loop Driving

Designing of a Micromachined Gyroscope System with a Closed-Loop DC Biased Interface ASIC

Digital closed-loop driver design of micromechanical gyroscopes based on coordinated rotation digital computer algorithm

Design of a Driver Circuit for Rotation of Micromachined Gyroscope

Transient response and stability of the AGC-PI closed-loop controlled MEMS vibratory gyroscopes

Design and Test of a Self-Oscillating Driving ASIC for a Low-Q Gyroscope Based on PI Controller

Parametric drive of a Micro Rate Integrating Gyroscope using discrete electrodes