Abstract:The Swift test was originally proposed as a formability test to reproduce the conditions observed in deep drawing operations. This test consists on forming a cylindrical cup from a circular blank, using a flat bottom cylindrical punch and has been extensively studied using both analytical and numerical methods. This test can also be combined with the Demeri test, which consists in cutting a ring from the wall of a cylindrical cup, in order to open it afterwards to measure the springback. This combination allows their use as benchmark test, in order to improve the knowledge concerning the numerical simulation models, through the comparison between experimental and numerical results. The focus of this study is the experimental and numerical analyses of the Swift cup test, followed by the Demeri test, performed with an AA5754-O alloy at room temperature. In this context, a detailed analysis of the punch force evolution, the thickness evolution along the cup wall, the earing profile, the strain paths and their evolution and the ring opening is performed. The numerical simulation is performed using the finite element code ABAQUS, with solid and solid-shell elements, in order to compare the computational efficiency of these type of elements. The results show that the solid-shell element is more cost-effective than the solid, presenting global accurate predictions, excepted for the thinning zones. Both the von Mises and the Hill48 yield criteria predict the strain distributions in the final cup quite accurately. However, improved knowledge concerning the stress states is still required, because the Hill48 criterion showed difficulties in the correct prediction of the springback, whatever the type of finite element adopted.

Valid Blank Holding Force for Deep Cylindrical Cup

The Study of Load Curve of Critical Wrinkless Variable Blank Holder Force in the Process of Deep Drawing Cylinder Parts

The Optimization Study of Variable Blank Holder Force in the Process of Deep Drawing Cylinder Parts

Study on influencing rule of critical blank holder force of rectangular box flange wrinkling

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

Development of forming process for deep drawing of square cup with optimized blank holder pressure

Forming Limit of Sheet Metal in Cylindrical Deep Drawing with a Conical Die

An Analytical Prediction of Flange Wrinkling in Sheet Metal Forming

Contribution to mathematical modeling of cup drawing: the upper-bound analysis for inward pull (case II) in ring forming

Research on the Critical Blank Holder Force of Elliptical Heads

A New Ductile Fracture Criterion and Its Application to the Prediction of Forming Limit in Deep Drawing

Experimental Research on Critical Blank Holder Force of Rectangular Box Flange Wrinkling

Detailed experimental and numerical analysis of a cylindrical cup deep drawing: pros and cons of using solid-shell elements

The Study on Forming Principle in the Process of Hydro-Mechanical Reverse Deep Drawing with Axial Pushing Force for Cylindrical Cups

Application of Drucker–Prager Plasticity to Predict Fracture in Rectangular Cup Drawing of AZ31 Alloy Sheet

A Mathematical Model for Determination of Limiting Blank Holding Force and Cavity Pressure in Hydromechanical Deep Drawing

A Study on Yield Criteria Influence on Anisotropic Behavior and Fracture Prediction in Deep Drawing SECC Steel Cylindrical Cups

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Deep Drawing of Rectangle Parts Using Variable Blank Holder Force

Study on Calculation of Black Holder Force in Deep-Drawing Rectangle

An Improved Ductile Fracture Criterion for Fine-Blanking Process