Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Forming Limit of Sheet Metal in Cylindrical Deep Drawing with a Conical Die

Finite Element Simulation of a Multistage Square Cup Drawing Process for Relatively Thin Sheet Metal through a Conical Die

Forming Limits of a Sheet Metal after Continuous-Bending-Under-Tension Loading

Analysis of Drawing Process for Cigarette Lighter Shell Based on Dynaform

Die Design for Cylinder-shaped and Thin-walled Part

Electromagnetic pulse-assisted incremental drawing of aluminum cylindrical cup

Research on compound forming process of cup-shaped part with inner gear

Detailed experimental and numerical analysis of a cylindrical cup deep drawing: pros and cons of using solid-shell elements

A Novel Method for Friction Coefficient Calculation in Metal Sheet Forming of Axis-Symmetric Deep Drawing Parts

Sheet metal forming limits under stretch-bending with anisotropic hardening

A New Ductile Fracture Criterion and Its Application to the Prediction of Forming Limit in Deep Drawing

Numerical prediction of the limiting draw ratio for aluminum alloy sheet

The Reverse Deep Drawing with Hydraulic Counter Pressure and Its Numerical Simulation

Radial Lorentz Force Augmented Deep Drawing for Large Drawing Ratio Using a Novel Dual-Coil Electromagnetic Forming System

Strength Design and Structural Optimization of Cold Extrusion Die for Cylindrical Workpieces

Research on Micro-Deep Drawing Process of Concial Part with Ultra-Thin Copper Foil Using Multi-Layered DLC Film-Coated Die

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

SIMULATION AND ANALYSIS ON WRINKLING BEHAVIOR OF SQUARE BOX PART IN DEEP DRAWING BASED ON DYNAFORM

Diamond-coated tube drawing die optimization using finite element model simulation and response surface methodology

Study on Micro Deep Drawing Process and Die Design

Sheet Bulk Forming of Thin-Walled Components with External Gearing Through Upsetting Using Controllable Deformation Zone Method