Abstract:Since microforming is very suitable for the mass production of micro parts, it gains widely attentions in recent years. With the miniaturization of parts, the ratio of contact area to volume becomes larger, which leads that friction has more and more effects on microforming process. In this investigation, a micro U-deep drawing device is developed, and a precision load sensor is embedded in the die to directly measure punch force in the U-deep drawing process. A series of female die is selected with the cavity width of 0.6-1.4mm to study the effects of female die dimension, and the clearance between the female die and punch is equal to the thickness of a specimen. T2 copper foil of 0.09mm in thickness is selected as experimental material. The dimensions such as width are changed to investigate the effects of contact area. To investigate the size effects of tribology in details, several kinds of lubrication are applied. The surface topography of specimens is modified using an electrochemical polishing process. The results show that the dimensions of specimens have an obvious effect on the friction coefficient. With the decreasing of specimens, the friction increases clearly. Size effect of tribology behaviour occurs. The surface topography of specimens before and after polished is observed with the confocal laser scanning microscope. The results indicates that the polishing process is very helpful for improve surface quality, which reduces the friction for the larger specimen. However, friction of polished specimen is slightly higher than that of original specimen when a small specimen is applied. An increasing model of contact area is developed to explain this phenomenon.

Study on Micro Deep Drawing Process and Die Design

Experimental and Numerical Study of Micro Deep Drawing of Copper Single Crystal

An Experimental And Numerical Study Of Micro Deep Drawing Of Sus304 Circular Cups

Micro Deep Drawing of T2 Copper Foil Using Proportional Decreased Tools

Micro Deep Drawing of Micro Cups by Using Dlc Film Coated Blank Holders and Dies

Effects of Lubrication Conditions on Micro Deep Drawing

Size Effect of Tribology Behaviour in Micro U-Deep Drawing with T2 Copper Foil

Research on Micro-Deep Drawing Process of Concial Part with Ultra-Thin Copper Foil Using Multi-Layered DLC Film-Coated Die

Grain Size Effect on Multi-Stage Micro Deep Drawing of Micro Cup with Domed Bottom

Discussion about the effect of size effect on micro deep drawing

Micro-hydromechanical Deep Drawing of Metal Cups with Hydraulic Pressure Effects

Effect of Die Cavity Dimension on Micro U Deep Drawing Behaviour with T2 Foil

Experimental and numerical study on the micro-forming of copper multi-crystal

Size effects on process design of micro deep drawing

Experimental Research on Micro-Deep Drawing Processes of Pure Gold Thin Sheet Using DLC-coated Female Die

Design of the Deep Drawing Die for Milli-component

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Effect of lubrication conditions on U deep drawing with copper thin sheet

Deep Drawing Process Simulation of Pure Aluminum L2 Considering Intrinsic Length

Simulation of defects in micro-deep drawing of an aluminium alloy foil

Application of multi draw radius deep draw die for increase in formability of redrawn cylindrical cups