Abstract:Deep drawing is the most advanced sheet metal forming technique. In today’s demanding environment is the global environment and energy saving, the process has been supposed to play a vital role in light-weight component industry. Light-weight, high strength, low density and extreme corrosion aspects must be almost guaranteed in a deep drawn product. However, due to those requirements, thinning and wrinkling and other defects will be increased also. Numerous elements such as blank-holder pressure, punch force, speed of punch, blank shape, thickness variation, surface-to-surface friction coefficient, material characteristic,...influenced to the success of methods as well as the quality of the products. In addition, worldwide manufacturers keep getting the most goods done in less time. Indeed, the increasing of productivity should be also dealt because it proportionally relates to the stamping speed. This paper investigates the influence of punch velocity on deformation behavior of aluminum alloy 5052–H112. Finite Element Method was used to perform Nakajima test at several of punch velocities of specimen widths and monitor fluctuations in magnitude of von Mises stress, the major strain and minor strain. Forming Limit Curve (FLC) was obtained at different velocities and almost uniform. Stretching and sliding across the top of the punch resulted in thinning of sheet metal. Beside this, the action of punch stroke resulted in the production of more von Mises concentrated stress and the largest specimen in widths had shown the peak value of von Mises stress compared with the other specimens at all different velocities. Furthermore, the ratio of the major strain to the minor strain is influenced by the mass of material at the contact area and keeps consistent over the variation in velocities of punch. This will pave the way for future studies of the optimization of the stamping speed in deep drawing.

Simulation of defects in micro-deep drawing of an aluminium alloy foil

Numerical Simulation of Cavity-Filling Procedures for Micro-Pin-fin Array Thixoforming with Semi-Solid A356 Aluminium Alloy

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

On the Size Effects in Micro/meso Semisolid Extrusion–forging of A356 Aluminum Alloy

Simulation of 3d Chip Shaping of Aluminum Alloy 7075 in Milling Processes

Finite Element Simulation and Analysis of Aluminum Alloy Three-Dimensional Milling

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Defects in Micro Hot Embossing Process

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Demolding Defects and the Design of Demolding Device in Micro Hot Embossing Process

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Anisotropic plasticity deformation during micro-deep drawing of 304 foils: An experimental and numerical investigation

Feasibility evaluation of failure models for predicting forming limit of metal foils

Prediction of defects in deep drawn rectangular parts using Finite Element Analysis (FEA) and Response Surface Methodology (RSM)

Analysis of the Stamping Speed for Sheet Metal Forming of Aluminum Alloy 5052-H112

Study on warm forming process of rigid-flexible composite drawing based on numerical simulation

Research on Micro-Deep Drawing Process of Concial Part with Ultra-Thin Copper Foil Using Multi-Layered DLC Film-Coated Die

Deformation behavior and interface microstructure evolution of Al/Mg/Al multilayer composite sheets during deep drawing

Failure Prediction in Bulk Metal Forming Process

Finite Element Modeling for Deep-Drawing of Aluminum Alloy Sheet 6014-T4 Using Anisotropic Yield and Non-Afr Models