Abstract:Blank holder force (BHF) is one of the important process parameters in the deep drawing process. BHF helps produce defect-free components by controlling metal flow during the deep drawing process. If BHF is low, it causes wrinkling; otherwise, it causes the sheet to rupture. Therefore, optimization of BHF is an important issue in industries. One of the effective approaches to determining optimal BHF is to study forming force, thickness distribution, and wrinkles to produce a deep-drawn cup. The main function of this approach is that it minimizes the maximum forming force and prevents process limits. Therefore, this study aims to investigate the relationship between the BHF and forming force through experimental and simulation results. In addition, the effect of BHF on the thickness distribution and wrinkling is considered. Hence, numerical and experimental methods were employed for St14 and SS304L sheets with thicknesses of 0.5, 1, and 1.5 mm to achieve the objectives. Firstly, the simulation of the process was performed to study the mechanical behavior. Then, a set of experimental tests were conducted to validate the simulations. Finally, utilizing the experimental and numerical results, the optimal BHF value was determined. It was observed that the maximum thinning and maximum forming force are related to the forming process without BHF. Moreover, when the wrinkling at the edge of the part was removed by gradually increasing BHF, the minimum values of forming force and thinning were obtained. According to the investigations carried out on three thicknesses, it was observed that by reducing the thickness from 1.5 to 0.5 mm, the maximum forming force decreases in both SS304L and St14 sheets. However, the acquired results showed that the minimum optimal BHF is obtained in both sheets at a thickness of 1.5 mm. Overall, this research provides valuable experimental and numerical guidance for implementing the deep drawing process to manufacture cylindrical parts with minimum forming force required to save energy consumption.

Experimental Research on Critical Blank Holder Force of Rectangular Box Flange Wrinkling

Study on Calculation of Black Holder Force in Deep-Drawing Rectangle

Research on the Critical Blank Holder Force of Elliptical Heads

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Development of forming process for deep drawing of square cup with optimized blank holder pressure

Research on the non-uniform deformation of deep drawing tailor-welded square boxes

Effect of blank holder force on joining quality of the flat clinch-rivet process

Study on the mechanism of wrinkle flattening under internal pressure and the critical condition of dead wrinkle

Numerical investigation of tool parameter influence on the interlock forming during flat clinching process

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

EXPERIMENTAL STUDY OF THE BEARING CAPACITY OF INTERNAL|EXTERNAL FLANGE JOINTS SUBJECTED TO PRESSURE AND BENDING LOADINGS WITH VARIOUS ECCENTRICITIES

A New Equation of Load Curve of Critical Wrinkles Variable Blank Holder Force in the Warm Deep-Drawing of Twin-Roll Cast Mg Sheets

Investigation of the clinching process with rectangle punch

Experimental and numerical investigation to determine the optimal blank-holder force in deep drawing process based on forming force for SS304L and St14 sheets

Numerical Study on Buckling Behaviors of Thin-Walled Longitudinal Corrugated Cylindrical Shells under Axial Compression Loads

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Enhancing formability in deep drawing: A 3D finite element analysis of plastic wrinkling in AA2090 Al–Li alloy

Static and Dynamic Deformation Analysis and Optimization of a Fine Blanking Press Frame

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes