Abstract:Quaternary chalcogenide Cu 2 CoSnS 4 (CCTS) thin films were successfully prepared by spray pyrolysis on glass substrates in varying the precursor concentration and the thiourea volume. The effects of the precursor concentration and the thiourea volume on the formation of the CCTS phase were systematically investigated by X-ray diffraction, Raman spectroscopy, Energy-Dispersive X-ray Spectroscopy. The electrical resistivity at room temperature has been measured by the four probes method. It is shown that the crystallization of the stannite CCTS phase depends on both the precursor concentration and thiourea volume. The minimum volume of thiourea required to crystallize the CCTS phase depends on the precursor concentration, i.e. the CCTS crystallization needs higher volume of thiourea at low precursor concentration. For higher precursor concentration, the CCTS is poorly crystallized with the presence of secondary phases such as CuS 2 , CoS 2 , and CuCo 2 S 4 , while the crystallization domain is relatively large. The CCTS well crystallizes only in a narrow range of precursor concentration and thiourea volume. The relatively poor crystallization combined with the presence of secondary phases are harmful for the optical and electrical features of the CCTS film. Besides, optical transmission measurements of the optimized film showed an optical gap of 1.7 eV (~ 730 nm) and an absorption coefficient included between 10 4 and 10 5 cm −1 in the visible solar range. Furthermore, the optimized stannite CCTS films are compact exhibiting a relatively rough and granular surface due to the formation of copper sulfide nodules. The electrical resistivity of the optimized CCTS film is about 0.4 10 –2 Ω cm. These results suggest that the deposited films fit the requirements of absorbing layer in solar cells. The diode composed of Au/Cu 2 CoSnS 4 /SnO 2 films was investigated with current–voltage ( I – V ) measurements performed under dark and bright conditions. The series resistance, saturation current and ideality factor of typical diode is estimated to be 689 Ω, 1.15 10 –5 A and 3, respectively.

Electrical and Optical Properties of Cu2ZnSnS4 Thin Films Prepared for Solar Cell Absorber

Low-cost Fabrication of Cu 2 ZnSnS 4 Thin Films for Solar Cell Absorber Layers

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Preparation And Characterization Of Cu2znsns4 Thin Films And Solar Cells Fabricated From Quaternary Cu-Zn-Sn-S Target

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Synthesis and Characterization of Hydrazine Solution Processed Cu12Sb4S13 Film

An Investigation on Structural, Morphological, Optical, and Electrical Properties of Copper Zinc Tin Sulfide (CZTS) Thin Films Prepared by SILAR Method

Temperature Dependence of Phonon Modes, Dielectric Functions, and Interband Electronic Transitions in Cu2ZnSnS4 Semiconductor Films

Optical and Electrical Properties Study of Sol-Gel Derived Cu2znsns4 Thin Films for Solar Cells

Optical and Electrical Properties of Uniform Non-Toxic Cu2ZnSnS4 Nanocrystal and Its Application in Solar Cells

Structural, Electronic and Defect Properties of Cu 2 ZnSn(S,Se) 4 Alloys

CuSbS2 As a Promising Earth-Abundant Photovoltaic Absorber Material: A Combined Theoretical and Experimental Study

Study on the Optimization of Cu-Zn-Sn-O to Prepare Cu2ZnSnS4 Thin Film via a Nano Ink Coating Method

Structural, Electronic and Defect Properties of Cu<sub>2</sub>ZnSn(S,Se)<sub>4</sub> Alloys

Investigation of Cu2ZnSnS4 thin film with preannealing process and ZnS buffer layer prepared by magnetron sputtering deposition

Effect of the stacking order, annealing temperature and atmosphere on crystal phase and optical properties of Cu2SnS3

Study of optical and structural properties of CZTS thin films using copper capping layer and sulfurization to correct stoichiometry.

Preparing Cu2ZnSnSe4 thin film solar cells based on selenium containing precursors

Crystal Structure and Defect Reactions in the Kesterite Solar Cell Absorber Cu[sub 2]znsns[sub 4] (CZTS): Theoretical Insights

Fabrication of Cu2SnS3 Thin Film Solar Cells Via a Sol-Gel Technique in Air

Synthesis of Cu2CoSnS4 chalcogenide thin films by spray pyrolysis and efficient Au/p-CCTS/n-SnO2 diode for cells solar applications