Abstract:<p>Aiming at the problem of thermal deviation in crossover pass of single tangential boiler, an on-line measurement method of radiation parameters of high temperature coal particles based on radiation spectroscopy was proposed. A measurement system consisting of an optical fiber spectrometer system and a water-cooled structure probe was developed, which was used to measure the radiation parameters of high temperature coal particles in crossover pass of the boiler. The radiation spectra at 500-1000nm band on the gas flow side of the final reheaters inlet section of a 660MW ultra-supercritical boiler were measured by the system. According to Planck's law, the distribution of coal particles temperature, emissivity and other parameters along the section was obtained by fitting parameter method. The results show that the burnout delay of pulverized coal particles caused by the air-stage combustion system and the radiant heat transfer deviation caused by the non-uniform concentration of coal particles are the main causes of the thermal deviation of the final reheaters. Under the condition of increasing yaw angle of SOFA nozzles, the ability of SOFA to alleviate the residual swirling flow is significant, and the temperature distribution of coal particles in the crossover pass is more uniform. However, due to the phenomenon of single-side particles accumulation still exists, the deviation of particles radiation intensity remains large, which cannot effectively reduce the steam temperature deviation in reheaters. Through differentially adjusting the angles of SOFA nozzles in vertical direction and horizontal direction, the phenomenon of single-side coal particles accumulation can be improved, the non-uniform radiation heat transfer of heat exchangers on both sides can be balanced, and the steam temperature deviation in final reheaters can be reduced.</p>

The Calculation of Radiative Transfer Inside Pulverized Coal Boiler Based on Backward Monte Carlo Method

Computation of Radiative Heat Transfer in Participating Media Using Backward Monte Carlo Method

A Study of the Infrared Radiative Transfer of an In-chamber Small-sized Detector Based on a Backward Monte Carlo Method

Calculation of the Radiation Heat Transfer in Cylinder of Diesel Engine by the Monte-Carlo Method

Simulation of the infrared radiation characteristics of high-temperature exhaust plume including particles using the backward Monte Carlo method

Modeling and Experiments for Heat Transfer Process in Pulverized Coal-Firing Furnace with Two-Dimensional Radiation Characteristics

Three-dimensional Monte-Carlo Modeling of Radiative Transfer in a Municipal Solid Waste Incinerator

Efficient inverse radiation analysis of temperature distribution in participating medium based on backward Monte Carlo method

Calculation on In-furnace Heat Transfer of Large (ultra)supercritical Coal-fired Boilers

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Numerical Simulation of Combustion and Pollution in a 330MW Opposed Firing Boiler

Simulation of Pulverized Coal Combustion Process Considering Turbulence-Radiation Interaction

Experimental Reconstructions of Flame Temperature Distributions in Laboratory-Scale and Large-Scale Pulverized-Coal Fired Furnaces by Inverse Radiation Analysis

Study on Calculation Method for Partition of Heat Transfer in an Ultra-supercritical Boiler

Prediction on pulverized coal combustion process in the boiler using computer simulation

300MW BOILER QUASI-THREE-DIMENSIONAL TEMPERATURE FIELD FAST RECONSTRUCTION BASED ON INTERPOLATED FILTER BACK PROJECTION METHOD

A Real-Time Calculation Method to Improve Boiler Safety in Deep Peak Shaving Cases

STUDY ON SECTION TEMPERATURE MEASUREMENT OF POWER PLANT BOILER BASED ON FLAME IMAGE

Measurement of thermal deviation of flue-gas in crossover pass of single tangential boiler

The Application of a Radiation Discrete Transfer Method for the Radiation Heat Transfer Calculation of a Three-dimensional Cylindrical Cavity Body

Simulation Study on Radiative Imaging of Combustion Flame in Furnace